PDS22MBWCBB General Electric Refrigerator - Instructions

Very simple fix by replacing the mother board. Your "how to" video made the repair even easier. The appliance repair estimate was over $400. I saved over $200. I already recommended your site to several other people. Thanks for making it so easy

On the internet forum I read that if the control board needs to be changed , do the same for the Run Capacitor/relay.
The Ge profile refrigerator was 15 years old. First I disconnect the power cord,
I removed the control board at the back of the fridge, replaced it with a new one and did the same for the run capacitor.
Plugged the power cord back and it works fine. GE repair service did not want to come to do it. DIY is fine.

Cleaned mating surfaces with acetone using vapor mask because done indoors. No instructions as to which cleaner to clean old glue off. Matting surfaces. No nistructions as to what glue to use so used silicone. We'll see if it holds up

Easy

the new board was more complicated than the old, however the install instructions seem to have anticipated this. It works for mow. thanks for inquiring'

removed cover from rear of refrigerator. disconnect mother board connections. Unplug first, used needle nose pliers to squeeze plastic tabs holding on motherboard and replaced old with new and plugged back in connections. Plug back in refrigerator and done.

I easily removed the screws and then removed the board and took a picture so I would remember how to re-connect it. It was really easy and now my refrigerator is working great. If I can do it anyone can do it. My husband was amazed that I did it all by myself.

Moved fridge out from wall. Unplugged. Removed circuitboard cover 6 screws?). Replaced circuit board (showed burn spots on back side). Replaced cover and plugged back in.

very easy repair, simple exchange

Removed the screws on the back panel with a nut driver and then removed the old board from the back. Rehooked the connections and replaced board and backing.
Repairman wanted to charge $400 for parts and labor. Saved $150 because he charged to diagnose the problem.

I unplugged the refrigerator. I removed cover plate with nut driver. I removed all wire harness plugs from old board and removed old board using needle nose pliers to squeeze existing holding clips. Old board came right out. I then snapped new board into place and replaced all the plugs. I replaced cover with nut driver and plugged in the refrigerator. Its been two weeks and all seems to be working fine.

Opened the back panel and removed the old board and replaced it with the new one. The new board had a couple of extra connectors that are not used. Replaced the cover and turned it back on, everything was working fine after that. This is the second refrigerator that has lost the main board in a month, Putting surge suppressors on both.

Unplugged side by side took about 4-5 screws out removed plate from back, unplugged the wires removed old board and plugged wires in new board, note: new board a little different than original. Screwed plate back in. So far so good. I do not think I will buy any more ge appliances, this one was very expensive but out of warranty now my ge dishwasher is making noise all purchased at same time.

I read other reviews then decided it was my main control board.Watched the video for install. It was easy to change out.Everything is working great again.

I ordered a new electronic board from GE. Took the cover off of old board located on back of refrigerator. Removed old board and installed new. Instructions were included. I also visited the GE website and watched an installation video. Very good instructions.