GTT17BBSGRCC General Electric Refrigerator - Instructions

Unplug the refrigerator removed the condenser/ compressor cover back bottom on fridge, remove the relay from the compressor took off the two wires, replace with new relay

with a jewelry screwdriver I pried the lock tab in and pulled switch down carefully, the hardest part was that the power wire connector was stuck on good but the pliers and the jewelry screwdriver was its match for a bout 5 minute for one connection a simple pull off prong connection. After the wire connected back to switch it popped back in SNAPP

Pop out switch, pull wires, attach wires to new switch and pop back in. Easy smeasy!

Remove the top cover above the door by lifting it slightly and pulling forward. I used a mirror to make sure that there was nothing in the way of accessing the switch from above. I used a blade screwdriver to press against the switch retainer on the topside, while GENTLY prying from below with another blade screwdriver to get the switch dislodged. Once the retainer was past the opening, I wiggled the switch downward and then rotated it to the left when the rounded top right edge of the switch was visible. This allowed the wiring to the connector to pass thru the hole. I pushed the wiring from the top and pulled from below to get the connector below the opening for the switch. I then unplugged the switch, plugged in the new switch and reversed the removal process feeding the connector thru first then rotating the switch to the right to get the rounded edge of the switch thru the opening, then pressed the switch up into the opening until it snapped into place. Total time less than 10 minutes.

I lifted old one out and place new one in

It was way to ez to install only a couple of minutes that's it

took a little more effort than the video show to remove old module and replace new. Works fine now.

Easy

Took out vegetable draws, removed old cover and put in new vegetable pan cover. Then put back drawers.

Pulled the two wires out from the access hole in the lower part of the refrigerator. Put them in the spade connectors on the new switch, and pushed the switch into place.

First off, the part came the very next morning on Fed Ex regular 2-3 day service! It's an easy replacement, just drops right in and the vegetable drawers fit perfectly. I was concerned that there might be some sizing variation because of the age of the refrigerator, but it fit perfectly, perhaps better that the original shelf and it's made better and has a more useful top surface with fewer ridges. Excellent service, and excellent product.

just put it in and done. Great replacement part.

I removed the old shelf and even though the new one had a slightly different texture, it fit perfectly and the two crisper drawers slid right in.

All I had to do was remove what I had on the shelf, remove the bins, replace the shelf and slide the bins back in, replace what I had on the shelf and close the door. I am so happy now when I open the refrigerator door and the new (unbroken) shelf has replaced that old broken one.

Removed the drawers.Took out old cover by tilting up,Put New cover back on Tilting again to set it in ,brought it down on its rests and replaced the drawers.