GFSS6KKYASS General Electric Refrigerator - Instructions

In order to remove the condenser fan motor I needed to remove the fan blade. The blade is attached to the shaft with a press fit and there is a spring clamp that squeezes the blade to the shaft. Removing the spring clamp did not allow the fan to slide off the shaft because there must be some type of adhesive used in addition to the clamp. In forcing the blade off the shaft expect to damage the fan blade so that is why it was replaced. Very tight working area and difficult to get the leverage to pull on the blade.
The new blade will push on with a bit of force.

Watched repair video from this site cleaned off shelf, removed the two bins, lifted it out broken shelf, placed new shelf back in, returned the two bins. One step that would have helped a little would have been to remove the bottom door pockets. This would allow the bins to come out easier.

If this repair looks hard then you probably aren't doing it right. The key to doing this fairly easy upper hinge replacement is to pry the metal back off of the swinging panel attached to the door as a first step. Doing so exposes the screws that hold the hinges in the panel, and also the tabs that you must press in to release and remove the hinge covers. I accidentally broke the tabs on both hinge covers removing them, but I discovered that it didn't matter - I was still able to snap them both into place without having to replace them as well. Once you've released the hinge covers slide the panel upwards to reveal the entirety of the hinge, then push the hinge up with a flathead screwdriver so that it slides off of the anchor piece on the door. Slide the replacement part down onto the anchor, slide the swinging panel down and replace the hinge covers. From inside the panel reattach the screws (middle hinge only) and replace the panel parts including the metal back. Whole repair takes about 15 minutes.

Used a pair of needle nose pliers and replaced the spring.

Show how to fix it on YouTube so that helped a lot. I ordered a new spring gave all the correct information and the spring was too big that showed up
lol so had to go to Plan B an modified the broken spring lol works great now

Had to pay for entire shelf/hinges/ and backer plates. Aside from the high price, install was super easy. Pop off the two caps on the existing screws(Phillips head). Pull off old shelf and install new. Two screws, that's it! Just needed to reuse the screws and caps (did not come with new shelf).

This company has everything!! One simple spring was all I needed. Fast shipping and product was exactly what they said I needed. Took me less than a minute to fix!! I’ll definitely shop here again!!

Pulled one out. Put new one in.

Used pliers to put new spring in place;
Time took about 3seconds and I’m a female. Video provided very helpful.

0. As a safety precaution, unplug the range or hit the relevant fuse breaker before you start. You might also want to grab a flashlight. Definitely do not try to do this while the oven is hot.
1. Pinch the wire over the light bulb cap to remove it. This is inside the oven at the back.
2. Pop off the hemispherical glass cap.
3. Unscrew the old light bulb, and screw the new light bulb in its place.
4. Put the cap back.
5. Secure the cap by putting the wire back in its slots on the cap.

No tools needed, the cap is just held in place with pressure from the wire.

replaced lights in refrigirator and freezer

Placed one end of the new spring in left hole and used the needle nose pliers to insert the other end of the spring in the right hole.

Placed lower spring leg in hole first. Manipulated upper spring leg into upper hole with needle nose pliers.

Moved stuff out of my way on the top shelf, reached in and turned old filter to remove. Filled new filter with water, lined up and turned to lock in place. Whew, never thought I would get that job done. :-)

Spent a dollar 1.97 on the spring.7.00 on shipping and fixed it in less than 5 minutes.Fantastic