Models > GFSL6KKYBLS > Instructions

GFSL6KKYBLS General Electric Refrigerator - Instructions

Jump to:

All Instructions for the GFSL6KKYBLS

Customer:: Roscoe G from ROCHESTER, NY
Parts Used:: 40A15
Difficulty Level:: Very Easy
Total Repair Time:: Less than 15 mins

Light burnt out.

Turned the wire protector to the side. Turned out the old bulb and replaced it with the new. Turned the wire protector back in place and I'm like new.

2 of 8 people found this instruction helpful.

Was this instruction helpful to you?

Customer:: richard from asheboro, NC
Parts Used:: MWFP
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

needed to replace the filter

replaced the filter with the new one i purchased

0 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Customer:: Andrew from Bensalem, PA
Parts Used:: DA81-01345B
Difficulty Level:: Very Easy
Total Repair Time:: Less than 15 mins

French spring broke.

pushed new spring in.

6 of 26 people found this instruction helpful.

Was this instruction helpful to you?

Customer:: Fran from Mount Vernon, IA
Parts Used:: WR13X10808
Difficulty Level:: Really Easy
Total Repair Time:: 15 - 30 mins
Tools:: Screw drivers

Evaporator Fan Failure

Disconnect power to refrigerator, Removed all upper shelving, slid the draw assemblies out 12 inches to gain access to lower retaining screws using my power screwdriver. Removed three lower retaining screws and two screws that hold the center shelf rail. Then removed the cover assembly by pulling out and down from the bottom of the assembly until I could access the connectors for the fan at the upper left hand corner. After releasing the lock tabs for the electrical connectors I removed the assembly from the refrigerator cabinet. There was an excessive amount of ice/frost buildup due to the fan failing so I used a blow dryer set on low to thaw the ice from the evap coils and related wiring and sensors. Once thawed and free from ice, I reversed the procedure to install the new cover. The procedure would have only taken about 10 minutes if it were not for the ice buildup. I would recommend letting the frig thaw first if you have another place to store the food. Overall, very easy to install.

Was this instruction helpful to you?

Customer:: Karen from Medford, MA
Parts Used:: WR32X10662, MWFP
Difficulty Level:: Really Easy
Total Repair Time:: 15 - 30 mins

The plastic on the vegetable tray shelf was cracked

The repair was so easy. I had to take out all the food. Then I was able to easily lift the shelf out, and put the new shelf in and replace the vegetable drawers.

Was this instruction helpful to you?

Customer:: Richard from Waynesboro, PA
Parts Used:: MWFP
Difficulty Level:: Easy
Total Repair Time:: Less than 15 mins

replace water filter

Easy, with included video and instructions

Was this instruction helpful to you?

Customer:: Carole from Sunrise, FL
Parts Used:: WR32X10662
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

crack by the middle of vegi drwaer

easy slide out and put new one

Was this instruction helpful to you?

Customer:: Randell from Rancho Cucamonga, CA
Parts Used:: MWFP
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

Filter needed replacing

Very easy, unscrew and re-screw new filter in..

Was this instruction helpful to you?

Customer:: Jared from Sandy, UT
Parts Used:: WR72X10270
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins
Tools:: Screw drivers

Factory installed rail was overtightened and fractured the rail. Subsequent use resulted in rail failure.

Remove drawers and internal shelf supported by rail(no tools). Remove rail (phillips). Remove roller from existing rail. Intall roller on new rail. Install new rail (phillips). Replace shelf and drawers. Note: New roller (identified as a separate part) and screws are not included with rail.

Was this instruction helpful to you?

Customer:: Loren from Litchfield, MI
Parts Used:: WR32X10784
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

Broke side button on cover that holds it in

Just put it in the holes on both sides only problem is the printing on cover is up side down

Was this instruction helpful to you?

Customer:: Richard from La Grande, OR
Parts Used:: MWFP
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

water filter was aged and needed a replacement

unscrew filter and replace the new one

Was this instruction helpful to you?

Customer:: Dan from Surprise, AZ
Parts Used:: MWFP
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

We needed a new water filter.

We received the part just a few days after ordering, unscrewed the old filter by hand, and installed the new filter the same way.

Was this instruction helpful to you?

Customer:: Natalia from Mount Pleasant, SC
Parts Used:: MWFP
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

Water filter needed replacement

Removed the old filter. Filled the new one with water and put it in theplace of an old one. Flushed the system with 1 gallon of water.

Was this instruction helpful to you?

Customer:: Michele from Birmingham, AL
Parts Used:: WR21X10178
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

Broken plastic shelf cover

took shelf out, put back in! EAsy

Was this instruction helpful to you?

Customer:: David from San Antonio, TX
Parts Used:: MWFP
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

Poor water and ice taste, filter a few years old.

Very simple, I followed instructions sent with the filter. Twisted old filter clockwise 1/4 turn to remove. Filled new filter with water, lined up arrow on filter to arrow on refrigerator, and then turned 1/4 turn counterclockwise. Filter raised and seated itself. Wiped few drops of water from refrigerator shelf.

Was this instruction helpful to you?

All Instructions for the GFSL6KKYBLS