GFSF6KKXABB General Electric Refrigerator - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Deryl from KINGWOOD, TX
- Parts Used:
- DA81-01345B
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Door would not close properly
Spent a dollar 1.97 on the spring.7.00 on shipping and fixed it in less than 5 minutes.Fantastic
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Libor from Danbury, CT
- Parts Used:
- DA81-01345B
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers
door spring
replacing broken french door spring.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- David from NORTHWOOD, NH
- Parts Used:
- DA81-01345B
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers
Just follow instructions. Easy
Held spring with needle nose pliers and slipped into place
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- susan from hartford, WI
- Parts Used:
- MWFP
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
Bad tasting ice cubes
Took the old filter out and put the new one in.
Easy Breezy!!
Easy Breezy!!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Chris from OWASSO, OK
- Parts Used:
- WR17X12512
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers, Wrench set
Water flow 1 qt. Then slows
Water flow restrictions. Replaced flow valve. No help. Checked again and found filter head flow stopping valve broken. Replaced same. All good.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Catherine from SEATTLE, WA
- Parts Used:
- 40A15
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
The light inside the oven had burned out
0. As a safety precaution, unplug the range or hit the relevant fuse breaker before you start. You might also want to grab a flashlight. Definitely do not try to do this while the oven is hot.
1. Pinch the wire over the light bulb cap to remove it. This is inside the oven at the back.
2. Pop off the hemispherical glass cap.
3. Unscrew the old light bulb, and screw the new light bulb in its place.
4. Put the cap back.
5. Secure the cap by putting the wire back in its slots on the cap.
No tools needed, the cap is just held in place with pressure from the wire.
1. Pinch the wire over the light bulb cap to remove it. This is inside the oven at the back.
2. Pop off the hemispherical glass cap.
3. Unscrew the old light bulb, and screw the new light bulb in its place.
4. Put the cap back.
5. Secure the cap by putting the wire back in its slots on the cap.
No tools needed, the cap is just held in place with pressure from the wire.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- john from HAMPTON BAYS, NY
- Parts Used:
- WR60X10254, WR60X10255
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers, Wrench (Adjustable)
Warm refrigerator compartment.
Parts fit perfect. Very satisfied.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Joanne from Fort Smith, AR
- Parts Used:
- MWFP
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Auto water stopped working, found that filter needed replacement
Unscrewed old cartridge, ordered new cartridge, installed new cartridge by following very simple instructions. Took only one day for part to arrive from PartSelect although I paid for cheapest shipping, which was "ground." I was amazed!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- JAMES from MORENO VALLEY, CA
- Parts Used:
- MWFP
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Water dispensed at a trickle
I only had to remove the old filter and install the new one - all by hand. I then ran about 1 to 1and1/2 gallons of water through the filter to clear it.
A WORD OF CAUTION - HOLD YOUR GLASS CLOSE TO THE WATER DISPENSER FOR THE INITIAL FILLING - IT WILL SPIT UNTIL THE AIR IS PURGED FROM THE SYSTEM!!!
An extremely easy repair.
A WORD OF CAUTION - HOLD YOUR GLASS CLOSE TO THE WATER DISPENSER FOR THE INITIAL FILLING - IT WILL SPIT UNTIL THE AIR IS PURGED FROM THE SYSTEM!!!
An extremely easy repair.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- glen from PEABODY, MA
- Parts Used:
- WR30X10097
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Water leaking from ice maker
Unplug the harness slide ice maker out replace
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Roger from EDMOND, OK
- Parts Used:
- WR24X10211
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Gasket not sealing freezer door
Defrost unit pull old gasket out fo channel clean re install new gasket Easy Repair
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Cheryl from COLGATE, WI
- Parts Used:
- WR30X10097
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Stopped making ice
Removed faulty ice maker by sliding it out. Slid in new icemaker, re-connected electrical male/female that was obvious. Need to wait a few hours (7 or so is when we tested it and saw ice) before you see ice. Problem solved.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Steve from CARRIERE, MS
- Parts Used:
- WR72X10269
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
BROKEN VEGETABLE PAN RAIL
TOOLS NEEDED ARE A #2 PHILLIPS, A FLAT TIP SCREWDRIVER AND SOAP AND WATER FOR CLEANING OF THE VEGETABLE PAN COVER.
1. REMOVE BOTH VEGETABLE PANS.
2. REMOVE THE VEGETABLE PAN COVER BY SLIDING IT FORWARD ENOUGH TO BE ABLE TO LIFT IT UP AND OUT.
3. USING THE PHILLIPS SCREWDRIVER REMOVE THE 2 SCREWS HOLDING THE RAIL TO THE CASE.
4. IF THE REAR PART OF THE RAIL IS BROKED OFF AND STILL IN THE WALL OF THE FRIDGE (LIKE MINE WAS) REMOVE IT WITH THE FLAT TIP SCREWDRIVER BY PRYING IT OUT OF THE SQUARE HOLE . USE SOME PRESSURE IF NEEDED.
5. INSERT THE REAR PART OF THE RAIL (LOOKS LIKE A LANCE) AND PUSH IT IN ALL THE WAY TILL IT STOPS.
6. THE PHILLIPS SCREWDRIVER ANCHOR THE RAIL TO THE WALL OF THE FRIDGE FIRMLY, NOT TOO TIGHT.
7. USING THE SOAP AND WATER, CLEAN INSIDE OF THE FRIDGE AND ALL PARTS REMOVED.
8. LAY THE VEGETABLE PAN COVER ON TOP OF THE RAILS AND SLIDE IT BACK TO LOCK IN PLACE.
9. INSTALL THE VEGETABLE PANS.
10. WORKED FINE, LOOKS FINE AND LASTS A LONG TIME.
1. REMOVE BOTH VEGETABLE PANS.
2. REMOVE THE VEGETABLE PAN COVER BY SLIDING IT FORWARD ENOUGH TO BE ABLE TO LIFT IT UP AND OUT.
3. USING THE PHILLIPS SCREWDRIVER REMOVE THE 2 SCREWS HOLDING THE RAIL TO THE CASE.
4. IF THE REAR PART OF THE RAIL IS BROKED OFF AND STILL IN THE WALL OF THE FRIDGE (LIKE MINE WAS) REMOVE IT WITH THE FLAT TIP SCREWDRIVER BY PRYING IT OUT OF THE SQUARE HOLE . USE SOME PRESSURE IF NEEDED.
5. INSERT THE REAR PART OF THE RAIL (LOOKS LIKE A LANCE) AND PUSH IT IN ALL THE WAY TILL IT STOPS.
6. THE PHILLIPS SCREWDRIVER ANCHOR THE RAIL TO THE WALL OF THE FRIDGE FIRMLY, NOT TOO TIGHT.
7. USING THE SOAP AND WATER, CLEAN INSIDE OF THE FRIDGE AND ALL PARTS REMOVED.
8. LAY THE VEGETABLE PAN COVER ON TOP OF THE RAILS AND SLIDE IT BACK TO LOCK IN PLACE.
9. INSTALL THE VEGETABLE PANS.
10. WORKED FINE, LOOKS FINE AND LASTS A LONG TIME.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- WILLIAM from NORTH OLMSTED, OH
- Parts Used:
- WR30X10097
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
The icemaker quit working
Had to remove the old icemaker and then steam out the water passage in the refrigerator.
New one works fine.
New one works fine.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Louis from LEAGUE CITY, TX
- Parts Used:
- 40A15
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Nutdriver
Change bulb
Easy
Was this instruction helpful to you?
Thank you for voting!