Models > DSS25KGTEBB > Parts

DSS25KGTEBB General Electric Refrigerator - Parts

Jump to:

1 - 12 of 154
Keep searches simple, eg. "belt" or "pump".
Keep water and ice properly filtered with this updated refrigerator filter. It installs in the upper right corner of select refrigerator models. Turn the old filter left to remove it, then align the a...
In Stock
Order now and your part arrives by Nov 21
The main control board relies on this thermistor, or temperature sensor, for readings from inside the refrigerator or freezer. Those readings guide cooling decisions, including when the compressor and...
In Stock
Order now and your part arrives by Nov 21
A leak, a dispenser that will not flow, or an ice maker that will not make or dispense ice can point to the refrigerator water inlet valve. This OEM assembly controls water flow and includes a guard. ...
In Stock
Order now and your part arrives by Nov 21
This electronic board (Main Control Board Assembly, Control Board, Motherboard) controls the temperature and defrost functions of the unit. This control board is located on the back of the refrigerato...
In Stock
Order now and your part arrives by Nov 21
This ice dispenser solenoid is used to move the linkage that opens the ice chute door when dispensing is activated. When power is released, the mechanism allows the flap to close and limit warm air en...
In Stock
Order now and your part arrives by Nov 21
After the ice dispenser is used, this recess door spring brings the chute door or dispenser lever back to its resting position. The spring is housed behind the control panel in the water and ice dispe...
In Stock
Order now and your part arrives by Nov 21
This genuine OEM light switch is used to control the light in your refrigerator. When the fridge door is closed, it depresses the switch and turns the light off. When the fridge door opens, it release...
In Stock
Order now and your part arrives by Nov 21
This fan motor is most times used with frost-free refrigerators with a condenser coil. When the compressor runs, so does this fan, circulating air through the refrigerator grille, cooling the compress...
In Stock
Order now and your part arrives by Nov 21
This OEM compression ring is used to hold the evaporator fan motor in place. Signs that you may need to replace the compression ring are if the fan is noisy, or your fridge or freezer are too warm. We...
In Stock
Order now and your part arrives by Nov 21
$15.26
This genuine OEM replacement part is a bumper for your refrigerator. The bumper is made of orange rubber and measures less than half an inch in diameter. The bumper is used to prevent the fan motor fr...
In Stock
Order now and your part arrives by Nov 21
Control the opening and closing of the ice chute door with this plastic dispenser crank. It sits behind the dispenser interface on the inside of the freezer door and moves when activated by the dispen...
In Stock
Order now and your part arrives by Nov 21
This part holds the ice once it's released from the icemaker. When activated, the auger rotates and pushes ice out of the bin through the chute to the user.
In Stock
Order now and your part arrives by Nov 21
1 - 12 of 154