ESH22XGPCBB General Electric Refrigerator - Parts

This evaporator fan blade is for your refrigerator, and it circulates air so that the temperature of the fridge is regulated. This model has 3 blades, and is a little more than 4 inches in diameter. I...

This part is a replacement filter bypass cap for your refrigerator. If you intend to use an external water filtration system for your refrigerator, the bypass cap will allow you to do so. To use a fil...

This pan does not include the handle. Must order separately or use original.

This part helps to contain parts for the ice and water dispenser. The overlay and dispenser board is attached on the front of the housing shield.

Coarse thread

This is a replacement vegetable pan handle. If the vegetable pan or crisper in your refrigerator has a broken or missing handle, this is the part that replaces it. The handle is made of white plastic ...

This part is the replacement crisper drawer front gasket for your refrigerator. It is white in color and is approximately 16 inches long and ¾ of an inch wide. The gasket helps create a seal for your ...

This is a replacement evaporator fan grommet for your refrigerator. The fan grommet absorbs the vibration from the evaporator fan motor for quiet operation while it runs. If your evaporator fan is unu...

This part is a replacement dispenser grille tray for your refrigerator. It is sold individually and is an OEM part from the manufacturer. This dispenser grille tray sits below the ice and water dispen...

This snack pan, also known as drawer, is made to hold food items in your refrigerator. It is clear in color and measures about 15 inches by 15 inches at the base of the pan. It is made entirely of plastic.

This is the replacement micro switch, or dispenser switch for your refrigerator. It is gray in color and measures approximately 1 inch by half an inch. The dispenser switch is what tells your refriger...

This motor is used to activate the blades to crush the ice for dispensing. This part is now threaded with a left hand thread and the J nut is no longer required.