Models > TCD18PADARWW > Instructions

TCD18PADARWW General Electric Refrigerator - Instructions

Jump to:

All Instructions for the TCD18PADARWW
16 - 23 of 23
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Miranda from Waterford, CT
Parts Used:
WR2X9296
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
The end cap on the door shelf snapped off.
I pulled off the broken piece, ordered the new piece, and snapped it on. VERY SIMPLE.
0 of 1 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Matthew from Philaelphia, PA
Parts Used:
WR2X9296
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Broken shelf support on the refrigator door
I matched the part I needed throught your web site. Then I called and spoke to a customer support person, and gave my personal information to her. I do not like giving my credit card numbers over the internet. Your site allows me to do that.
0 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Leonard from Niagara Falls, NY
Parts Used:
WR2X9295
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
door shelf end cap broke off
easily popped the new one in.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Lawrence from Seaboard, NC
Parts Used:
WR50X133
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
defrost heater would not come on
Removed old defrost heater, cut wire then put heat shrink tubeing on wire,spliced wires slid tubing over splice applyed heat. JOB NONE
Was this instruction helpful to you?
Thank you for voting!
Customer:
Oleg from Lees Summit, MO
Parts Used:
WR2X9295
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Reistall shelf
Replaced cap and reinstalled. But I used iron nail inside cover to hold right side because crack was at right hole and right part would not help.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Mark from Moraga, CA
Parts Used:
WR50X133
Difficulty Level:
A Bit Difficult
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
Refrigerator (top warm) but Freezer Fine
-- Hardest part was removing the section to get into the Defrost Thermostat. Used a hand scraper to push plastic piece back wards (39 in parts diagram) once pushed back about 1/4" it then pops up and can come out (towards the front). Noticed that the evaporator was full of ice and the fan was working). Replaced Thermostat after defrosting evaporator... works like a charm.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Charles R from Renton, WA
Parts Used:
WR60X203
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers
The bottom part of fidge was warm with water droplets on the its ceiling.
Removed Ice shelf,
Remove rectangle cover by removing the two screws and lifting straight up.
Pulled fan off slowly.
Removed two hex screws holding motor bracket.
Remove cover.
Remove two hex screws holding remaining bracket from fridge.
Pull wire off motor noting where they were plugged in.
Pull apart brackets holding motor and remove motor noting how the motor and brackets fit together.
Reverse to install.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Janice E from Dominguez Hills, CA
Parts Used:
WR51X10027, WR50X133
Difficulty Level:
A Bit Difficult
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
refrigerater could not defrost
I order the parts and went from there. Actually a very nice friend of mine did the labor. It took longer to defrost it in order to get things running again. I was without my refrigerator for 4 months had I known the parts would be so reasonable instead of what a repair man wanted to charge I would have done it sooner. thanks
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the TCD18PADARWW
16 - 23 of 23