TBX14SAZHLWH General Electric Refrigerator - Instructions

I simply removed the old cover and replaced it with the new one! Fit was perfect. Thanks!

I emptied the contents of the shelf, removed the damaged shelf and put the other chauvinist place. The time from start to finish, including emptying the shelf, under two minutes.

Slipped out the old broken cover and slide in the new one. We never thought the cover could be replaced because our refrigerator more than 10 years old. This experience really was an eye opener. Sien

Took old shelf out, put new one in. Not rocket science. Really really simple

Simply removed the old and replaced with the new one.

The key is that I received the part within three days and it was perfect. I have the site bookmarked...but hoping I'll never need to call you. Thanks!

Not really a repair, just replaced the vegetable drawer tray, I just set the part in and it fit perfectly.

ordered the part and installed without any tools. The order also arrived in a day or two which was surprising.
I will use this service again if needed for parts. The service was great!

Simply removed all items on lower shelf then removed the old dried up lime that was used to prop the broken pan before. By the way it was placed there about 3 years ago.Anyhow tossed the lime cleaned the area and easily installed the new pan cover , Thank you Part Select .com i definetly will use u all again. Until the next broken part .

First off, the part came the very next morning on Fed Ex regular 2-3 day service! It's an easy replacement, just drops right in and the vegetable drawers fit perfectly. I was concerned that there might be some sizing variation because of the age of the refrigerator, but it fit perfectly, perhaps better that the original shelf and it's made better and has a more useful top surface with fewer ridges. Excellent service, and excellent product.

just put it in and done. Great replacement part.

Took old cover off, put new cover in.

I removed the ice tub. Removed the screw on the left side that holds closed the section where the icemaker plug is connected. Disconnected the plug. Then removed the bottom right screw. I was then able to remove the Icemaker by unhooking it from the bcak freeze wall. I disconnected the icemaker from the fan gaurd. Removed the icemaker cover. unscrewed the 3 icemaker screws and opened up the chamber. removed the old Ejector Blade Drive Cam by removing the outer srew that hold the gear to the icemaker. changed the cam with the new one and reassembled everything.

I removed the lower screw (not needed for the new icemaker), loosened the 2 top screws, unplugged the wire harness and removed the old icemaker. Unpacked the new icemaker assembly from the box, wiped the ice cube depressions to remove any debris, snapped on the water tube adapter, hung the new assembly on the 2 loosened upper screws and tightened the screws. The wire harness required the supplied pigtail plug which made the wire assembly long and awkward to replace the ice bucket/dispenser assembly, plugged it in and was done. It took a total of about 10 minutes for the entire operation and had a full bin of ice cubes within 36 hours and was ready for the ice dispenser/crusher in the freezer door. Easy install!

Used the nutdriver to loosen two screws, life out ice maker, disconnect electric plug and put aside. Placed the new icemaker on the loosened screws, plugged in electric connector and tightened screws. Used small level to verify that unit was level.Waited about two hours for first cubes to be released into tray - has been working fine since!

it was slowing cracking for a long time, and repairs with duct tape and crazy glue were a futile attempt to avoid the inevitable; a new part altogether! Well a few moments searching your site for the exact piece were all that was needed. With 48 hours of placing the order I had it in my apartment and just slipped it into place! it was a piece of cake!Thank you so much!