GSS22IBTC General Electric Refrigerator - Parts

The temperature sensor, also referred to as a thermistor, is used to monitor the refrigerator and freezer internal temperatures. The sensor is a small capsule like device that is protected by a white ...

This genuine OEM part is the right side of the slide rail for the crisper drawer in your refrigerator. This rail is attached to your fridge wall with two screws and will require a Philips screwdriver ...

This drawer slide rail is a genuine OEM replacement part for the crisper drawer shelf in your refrigerator. This rail is for the left-hand side of the shelf assembly. If you need to replace both sides...

This dual heater kit replaces the single heater. It's redesigned to use two heating elements for a better defrost cycle.

This authentic OEM part is a clear plastic dairy door for your refrigerator. It is found on the interior of the fridge door and rotates open and closed so that you can access the dairy compartment. If...

The vegetable drawer, also known as a crisper drawer, is used to keep fresh produce at the optimal temperature and humidity level. These drawers can become damaged over time from regular wear and tear...

This grommet is found on both the front and back of the fan motor assembly for the condenser and the evaporator in your fridge. It is used to provide a buffer between the fan motor and the mounting br...

This is a drawer slide rail for the right side of your refrigerator. It is located on the bottom of the unit, mounted to the right side of the cabinet wall. The purpose of this part is to hold the she...

This fan motor is most times used with frost-free refrigerators with a condenser coil. When the compressor runs, so does this fan, circulating air through the refrigerator grille, cooling the compress...

This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated. Note: Therm...

This genuine OEM replacement part is a bumper for your refrigerator. The bumper is made of orange rubber and measures less than half an inch in diameter. The bumper is used to prevent the fan motor fr...

This drawer slide rail is for the left side of the refrigerator, and allows the bottom shelf to slide in and out. If your refrigerator door will not close, or the bottom drawer will not slide properly...