Models > FGHS2631PF5A > Instructions

FGHS2631PF5A Frigidaire Refrigerator - Instructions

Jump to:

All Instructions for the FGHS2631PF5A
121 - 135 of 596
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
David from HILLIARD, OH
Parts Used:
241969501
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Frame of meat drawer cracked
Took out old frame by removing drawer then lifted frame out. Lifted glass panel out of frame, place glass panel in new frame, places frame back in refrigerator and slid drawer back in. Easiest repair ever and I repair nothing myself!
4 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
James from Chesapeake, VA
Parts Used:
241969501
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
broken frame
removed broken one and slid in new one, put in glass.
4 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
thomas from buffalo, NY
Parts Used:
242126602
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Cracked bin
Inserted unit
4 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Ron from NORMAN, OK
Parts Used:
242126602
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Broken door shelf
Just popped it in.
5 of 7 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Donna from CULPEPER, VA
Parts Used:
241969501
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Frame around deli drawer cracked
Removed and inserted new. Easy peasy
4 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Steve from SARASOTA, FL
Parts Used:
5304527931
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
Our display was showing incorrect temps and would not light up the ice selections.
Unscrewed 4 screws and disconnected interface cables. Simple, very easy repair with complete correction of both temp and selection option lights. Instructions that came with the interface board were easy to read and understand.
4 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
JUDY from LAKE OZARK, MO
Parts Used:
240323002
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Broken plastic door bin
Replaced the bin took less than 5 minutes. Very impressed with the service we got. The part came in 1 day!!
4 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Harry from Orange City, FL
Parts Used:
242252702
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers, Wrench (Adjustable)
freezer filled up with ice leaking from ice maker shut off valve bad
It was real easy took the lines off one by one put them on the new unit one by one same with the three plugs than tighten new unit back on fridge.
5 of 8 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Wayne from Westford, MA
Parts Used:
241684503, 241684001
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours
Tools:
Nutdriver, Pliers, Screw drivers
Rust on Front Plate and Drive Blade
Downloaded a schematic of the ice container. Disassembled the ice container, keeping track of which different type of screws went where. Followed the schematic to ensure proper sequence of blades and spacers. Manually rotated unit prior to installing into the freezer in case of binding. Finished.
6 of 11 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Jonathan from GREENVILLE, RI
Parts Used:
242221501, 242252702
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours
Tools:
Nutdriver, Pliers, Screw drivers, Socket set
Doesn't make ice / doesn't dispense ice
Removed and replace solenoid manifold valve in rear of appliance using inadequate You Tube video. Removed and replaced augur motor after dismantling various housings using a seriously mistaken You Tube video. The latter video informed us that the yoke that screwed on the motor's shaft was a reversed Left Hand thread. It wasn't at all, and we struggled to figure that out. The people that make these videos leave out steps that they thunk are obvious, but aren't at all.
4 of 6 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Allen from VERO BEACH, FL
Parts Used:
240356402
Difficulty Level:
Really Easy
Total Repair Time:
More than 2 hours
Ordered an additional door bin.
You order your door bin by phone to PartSelect and wait. Wait for about 3 1/2 weeks to get a cracked and unusable piece of plastic. Then reorder and wait. Wait for about 2 weeks to get another cracked door bin. Now you decide to use this part or send this one back also. Don't worry, you get charged for shipping only once. I decided to use the second bin. It was not cracked from top to bottom like the first one. I'll see how long it last.
4 of 6 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Gene LaFond from NAPAVINE, WA
Parts Used:
240351061
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
closed the door and broke the draw
The repair was not it. It was the customer service by the ladys that answered the phone. Both of them were the same as to give me a perpaid return shipping label and my money back. It was like being at the return desk at W.M. and not like at some of the on line service I have come to know...

Gene
3 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
wallace from GRETNA, LA
Parts Used:
241969607
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
broken draw lip
slide in new draw
3 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Jubal from OZARK, AL
Parts Used:
241685101
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Pliers, Screw drivers
Broken Drum
Had to disassemble the entire ice maker bucket. Simple and straightforward, didn't need any pictures or reference materials. Just time consuming.
3 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Mark from O FALLON, IL
Parts Used:
242221501
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Screw drivers
Ice auger not working to push the ice to the ice dispenser
Easy to remove the auger Motor and Solenoid, however, it didn't fix the problem. $300.00 into it I now have to purchase a circuit board for $382.00. Not a happy camper.
3 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the FGHS2631PF5A
121 - 135 of 596