Models > FFTR2126LB5 > Instructions

FFTR2126LB5 Frigidaire Refrigerator - Instructions

Jump to:

All Instructions for the FFTR2126LB5
121 - 135 of 474
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
JACOB from YOUNGSTOWN, OH
Parts Used:
241537103
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Refrigerator did not cycle
Installation was fairly straight forward. The major complaint is that the problem returned 2 weeks later. I don’t know if I care to re-invest in another switch.
Now what?
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Ben from FRANKLIN, TN
Parts Used:
240524102
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Noisy condenser fan
Remove lower cardboard refrigerator panel. Carefully pull existing cracked fan blade off of the motor shaft and replace with new fan blade. Reinstall cardboard panel.
2 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
edith from woodbridge, VA
Parts Used:
240314011, 240311303, 240516502, 240313703
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers
refer door hinges were lost during the move in to our first home.
The center door hinge was still attached to the refridgerator so I only had to install the bottom and top hinges. I also moved the door handles to the other side so the doors open the "right" way. The hinges were just 2 bolts and 3 screws. Now, just if the repair man from our home warrentee company would show up to fix the refridgerator. It's blowing hot air!!!
8 of 22 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Salvador from SANTA ANA, CA
Parts Used:
5303918202
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Pliers
Freezer worked, refrigerator didn't. Ice build up on coils.
Unplugged refrigerator. Emptied freezer and removed ice maker and cover, need to unplug fan. Defrosted coils with hot water. Cut wires to thermostat as close to it ad possible to leave extra wire in case of an error. Stripped wire in new thermostat and put in shrink plastic then the wire crimp connector joining both light blue wires making sure wires were in before crimping them. Repeated with other dark blue wire. After used the heat gun to shrink the protective white tubing. The only thing i found not satisfying was tge tubing. It was too wide and too small. When i shrunk it did not cover the whole connector and was loose. I had to use a glue gun to cover both ends of each wire connector. Hope this helps other users.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Michael from CHICOPEE, MA
Parts Used:
240495804
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
None fit perfectly
Just slid it down into place.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Chasya from SCOTTSDALE, AZ
Parts Used:
240338001
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Just bought a condo and fridge door bin was missing.
Looked up model number online and found this site . Prices were reasonable and ordered the bin. It snapped right into place.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Jesse from Edmond, OK
Parts Used:
240337901
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
My door shelf broke where the tabs connect to the door
I slid and locked the new shelf in place, easy!
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Benton R. from Elkton, VA
Parts Used:
240495804
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Hook on end of snap-on freezer bin broke.
The existing bin fell off when the hook broke as the freezer door was opened. Finding and ordering the replacement part was about as simple as it can be. Delivery time was less than a week. Replacing the bin was just a matter of snapping it in place, which took all of 5 seconds.
2 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Kasey from O'Fallon, MO
Parts Used:
240338101
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
had no shelf bin
Just snapped it on.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
james from BEECH GROVE, IN
Parts Used:
240338001
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
clip that held shelf bin in broke off
opened box that part came in snpped it in place
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
E from FORT WAYNE, IN
Parts Used:
240337901
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
a chip broke off the shelf at the "cliparea"
Snapped right into place
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Michael from YORK, PA
Parts Used:
240338001
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
shelf bin retainer had broken off
snapped the new bin shelf in and we were finished
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
James from PHILADELPHIA, PA
Parts Used:
5303918202
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver
Evaporator was freezing up and was running non stop
I tested the components in the refrigerator defrost function. I used digital multimeter and checked for continuity. Defrost thermostat must 32 degrees or lower.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Jerome from Lakewood, OH
Parts Used:
240337901
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Broken shelf retainer
It was simply a matter of slipping the new retainer into place -- a ten second job. I was VERY pleased with the service I received through PartSelect.com -- the part was available and was shipped immediately. I had it in two days. Thanks.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Willard from Plymouth, MA
Parts Used:
240385201
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
broken draw
Pulled Out Broken Draw then put new one in.
3 of 7 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the FFTR2126LB5
121 - 135 of 474