Models > FPHI2188PF4 > Instructions

FPHI2188PF4 Frigidaire Refrigerator - Instructions

Jump to:

All Instructions for the FPHI2188PF4
91 - 105 of 284
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
CECIL from PHOENIXVILLE, PA
Parts Used:
242193205
Difficulty Level:
Difficult
Total Repair Time:
1- 2 hours
Gasket was oversize and compression spline would not stay in door groove
Required a trip to the hardware store. Online research showed that Gorilla Glue would hold gasket in place and was recommended for that task. Needed to glue each side separately to keep the spline in the groove. Took far longer than it should have!
2 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Orlando from FT LAUDERDALE, FL
Parts Used:
241537103, 215846604
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Pliers, Screw drivers
Freezer no freezing the food
Disconnect the power. To install the Defrost timer which is located inside the console at the top of the fridge I followed a YouTube video. It is very easy. Keep in mind that the Defrost timer comes settled in defrost mode so the compressor will not start after the power is reconnected.There is a hole in the console just behind the Defrost timer where you engaged it with a flat driver and rotate the clock until the compresor start. Now the compressor works for 6 hours and stop for 20 minutes for the defrosting cicle. The freezer now is freezing the meat!!
2 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Robert from GUNTERSVILLE, AL
Parts Used:
242252603
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Wrench (Adjustable)
Water inlet valve stuck open
Turned off water to inlet valve. Unbolted valve from back of unit, disconnect water supply line from valve, disconnected water line to ice maker. Put on new compression ring around water supply line. Pressed ice maker line into new valve, installed valve back on unit, then connected main supply line to valve. Works like a charm.
2 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Howard from Sharpsburg, SC
Parts Used:
240350609
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Broken Glass
Order parts on sat.afternoon,and got part on Tues.aand installed in less them 2 min.
3 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Leonard from WARRINGTON, PA
Parts Used:
240338101
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Cracked shelf
Snapped it in shelf in designated slots
2 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Rosemary from FRUITPORT, MI
Parts Used:
242193213
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Old door seal was cracked and didn't seal tight.
Pulled off the old seal and put the new one on. No tools needed. It fit where it was supposed to and seals the door like new now! Thank you!
2 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
John from Pilesgrove, NJ
Parts Used:
240360801
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Lost the temperature control know
The knob came in the plastic package. It was the correct part. I opened the package and placed the knob on the prongs. Now it works fine.

Thanks
John S.
3 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Chris from Lockport, NY
Parts Used:
241639502
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
One blade broke from condenser fan
The part i recieved, from parts select was a larger in circumfrence (<1/4) than the original. However i was not aware of this until after i treid to repair it.

I removed the broken fan from the condenser. This was very sipmle.

When i pluged the refridgerator back in to the outlet the fan tried to start up but soon began to make aloud noise, due to there not being enough clerance.
12 of 32 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
janet from Parryville, PA
Parts Used:
242193213
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
torn and cracked gasket
Took off the old one, replace the new one in less than 5 minutes
2 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
James from FORESTDALE, MA
Parts Used:
242193213
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
door gasket torn on top
followed installation video on your website which was very helpful. Very easy repair. The packing material was great.
2 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
GEORGE from CAMBRIA HEIGHTS, NY
Parts Used:
241808201
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Broken Door Bin
I just replaced the door bin. It was very easy.
5 of 12 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Glen H from Land o Lakes, FL
Parts Used:
242201805
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
The crisper pan was broken.
Very easy.Thank you!
4 of 9 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Rod from Rio Rancho, NM
Parts Used:
240338101
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
old refrigerator door shelf broke
Installing the new shelf was easy.
2 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Shelley from KENSINGTON, NH
Parts Used:
242201805
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Frame cracked and became brittle
Put old glass in new frame drop one side under small lip of frame..done..perfect!
3 of 6 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Colline from PENDLETON, OR
Parts Used:
241798231
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver
Ice maker not making Ice
Unscrewed (loosen) screws lifted unit out unplugged electrical connection. plugged in unit hung on screws tightened screws and had ice in less then 1 hour. Rick
2 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the FPHI2188PF4
91 - 105 of 284