FRT21HS8PS1 Frigidaire Refrigerator - Instructions

The freezer was still making ice, but the fridge portion was barely cooler than room temp. I came to the website and saw that the defrost thermostat cured this problem over half the time. I was quite dubious because I don't see how that would affect the non-freezer part of the compartment, but since it was a cheap and easy-looking repair, I figured what the heck, lets see if that's it. Sure enough, it's like new again. I still don't understand it, but I'll take it. The repair itself is simple, just cutting out the old switch and splicing in the new. Two wires, and clip it to the copper tubing where the old one was. The switch is accessed easily after taking out four screws in the back of the freezer compartment. The only hard part was removing the ice-maker, and that's just because the two screws that hold it in are a little hard to get a good grip on. Alas, you have to get the ice-maker out to pull out the back panel, so there's nothing for it but to wheedle those screws out.

I went online to a you-tube video to assess the problem and watch the repair. Ordered the part on sunday before christmas and had it christmas eve! Easy 10 minute repair. Four screws held the cover on. Two screws held the timer. Unplugged the old timer an replaced. Put all the screws back and . . . . Done! Easiest repair I've ever done. Parts select did a great job, good price, very fast service! One happy customer!

Shelf was already removed so I just lined up the shelf to the notches in the door and pressed down. It was done.

It slips right on. The hardest was getrthe item unpacked. It was pacrvery well for shipment so it wouldn't get broken. This company has very nice customer service on the phone.

Just block the door up so it doesn't fall off, remove the two screws, replace hinge, and replace screws. My wife could have done it. Metal replacement part is much better than the original plastic that warped from day one.

Removed old tray and slid in the new ones

Very easy to do, as per the video instructions.

A no brainer, just unpacked and placed on top of crisper!

I followed instructions from website video. I have ordered two separate parts from this company. Both were delivered within three days in excellent condition. It was a pleasure dealing with PartSelect. I recommend them, without hesitation, to all my friends. Reggie Johnson, President, Success-Tapes.com

I looked inside and around the fridge until I found the Model number. Then I ordered what looked like the right part. Turns out it wasn't, so I called the number on the label where I found the Model number, and got a rep to help me pick out the correct door shelf bins. Once they arrived, they just snapped into place!

unhinged old bracket and installed new one very easy

Just took old knob out put new knob in real easy thank you jd

purchased a defrost theromast,took about 20-30 minutes to take apart & put back together.delivery was in one day from the time of my purchase.thanks for all ur help &prompt delivery.

Exactly as the video showed, except I had to take the evap coil cover off and use a hair dryer to thaw it out. It was still frosting up too much, so I ordered the thermostat as well. Both were really easy, once i saw the location of the defrost timer and the thermostat. Thanks for the great site, prices that put the big store to shame, and the good video too!

Used wood blocks to raise the door off the lower hinge bracket then unscrewed the suspect hinge. Cut a small shim, two layers of soda can, to place under the lower edge of the new hinge bracket and doubled the washers by using the old one to ensure I had adequate clearance for the door. After a little silicone lube I installed the new hinge bracket. All better now.