FPSC2277RF2 Frigidaire Refrigerator - Instructions

Straight forward repair. Remove the four screws holding cardboard back. Remove the 2 screws holding the valve. Unscrew the water lines and unplug the electrical connections. I would caution that it would be wise to either take a couple photos or write down the order of connection. Even though it is somewhat color coded and the water lines are different sizes, a photo removes any confusion. My old valve had threaded connections using brass nuts and ferrules. The new valve has push in connections so you need to cut the ferrules off.. When cutting off the tubing, be sure to cut square. An angled or "squished" cut will leak when pushed into the fitting. Attach the valve to the refrigerator with 2 screws and replace the cardboard back and you're finished. While you have the back off is a good time to clean the coils. I left my fridge out and back off for a couple of ice making cycles so I could check for leaks (how I know the tubing needs to be cut very square). All in all, a very easy fix.

Just place new filter and lock it!

I ordered the replacement part, and when it arrived, I used a flat-blade screwdriver to remove the two glides from the old drawer and installed them on the new drawer by snapping them into place. Then I removed the sliding humidity control from the old drawer using gentle pressure, and installed it on the new drawer. Then I slipped the drawer into its place, loaded the vegetables into it, and was done in less than 5 minutes.

Unscrewed 2 nut screws, pulled off broken guide, replaced new guide in position, screwed in the 2 nut screws. Slide in the basket. Done.

Simply installed new shelf. Was very pleased how easy it was to find the correct part on the website.
It took 3 hours to clean up the broken glass and 2 minutes to install the new one!

Removed exterior housing, sliding old unit forward to release. New unit went in easily. Caution wires don't get pinched.

The part was easy to install and solved the problem! We had ice within hours. Thanks PartSelect!

Removed broken parts and installed new ones. Only had a little problem getting supports out. I think they had sticky stuff from spills in the refrigerator that made it more difficult.

carefully removed retainer from old valve

Remove old one and put in the new one

I removed the old frame and the glass. I put the glass in the new frame and inserted the frame & glass in the shelf brackets. No tools required. Nothing difficult or tricky about the replacement and installation.

It took longer to remove the items from the shelf than to replace the new frame and glass.

I first ordered the wrong switch I called and got a return label and was refunded my money before even shipping the wrong switch I was helped for the right switch and it arrived in 5 days the replacement works perfectly very easy to install. Thank you

After sending PartSelect the info to their troubleshooting dept. about my ice maker, they recommended replacing the ice solenoid. I did so at a cost of $102. No change, turned out replacing the ice maker(did not purchase from PartsSelect) was the issue and works fine now.

So wasted $102. FYI the part took 6 days to arrive.

I put the new unit up to the old one to see exactly how it goes, took the 2 screws holding the unt off...Took the 3 water lines off with adjustable wrench, put back exactly the same way and it worked with no leaks

took out the glass popped out the cover and put the new one on and put the glass on. DONE