FGHI2164QE0 Frigidaire Refrigerator - Instructions

Remove everything from shelf drawer is under. Remove everything in drawer. Remove the drawer itself. Remove the shelf the drawer slides underneath of by lifting front of shelf until legs unhook, then wiggle or gently pull until it releases from pieces legs hook into (each leg has one hook). Shelf should pull out with rails and legs attached. Remove screw with philips head screwdriver. I used a Stanley brand nut driver with philips and flathead bits included, $5 at Wal-Mart. Remove the screw holding the rail and leg together. Remove rail and replace with like part. Install screw. Hang shelf. Install drawer. Put all yer stuff back on shelf and in drawer. $50 cause step-son's kids like to pull out drawer and hang on it, go figure. Very simple fix. Do not lose screw! I put all my parts (drawer, shelf, rails, screw) on my kitchen counter. Mate your rail by aligning flat side of rail to inside flat surface of leg. Takes about five minutes. I would say good luck but you will not need it. Thank you PartsSelect for having such a user-friendly website!

I opened the fridge, put the glass in the shelf, and closed the fridge. Very easy.

Easy..

It was just a matter of taking out 1 screw that held the old support, replacing the drawer support with the new piece and replacing the screw that held it on.

One screw to remove the old part, and screwed in the new one. Easy as pie. Keep the screw from the old part as the new one did not have one.

Dropped it in!! A two minute fix. No problem.

Two screws held the top of the handle to the door and one set screw held the bottom of the handle to the door. All I needed was a phillips screw driver and an allen wrench. It took less than 10 minutes.

Followed the video instructions and it works like a charm! To top it off, the part got to my house the day after I ordered it! Fantastic service!

pulled the draw out ,then unloaded shelf,removed shelf and unscrewed rails. I slid the rails of and put the new ones on screwed them back on and reassembled the drawer and shelf

Removed the one screw holding the rail, positioned the new rail and put the screw back in.

This was the best company I ever dealt with - the part arrived in less than 24 hours. Incredibly fast,
and the order was right the first time.

Removed the meat drawer from shelf. Removed shelf from fridge. There is one Phillips-head screw holding each support rail in place. Remove screw, and then each rail can be removed. Place each new rail in place, and then replace screw. Put shelf back in fridge and replace meat drawer. Total time -- about 5 minutes!

The most difficult thing was ordering the parts. The right rail is called "Drawer Support Rail - right side". Fairly self-explainatory. The left rail is called "Track". Fairly confusing. Luckily, PartSelect.com has very good photos of the parts that they sell, and one can figure it out. It would have been much easier if both left and right rails were named similarly.

1) Viewed the video 2) Got a screw driver 3) Removed the shelf/bracket assembly 4) Removed the old support 5) Reassembled and put back in place. It took longer to clean the dirty shelf than to fix the support. Very easy.

I had to tap the screw holes with a 8/32 tap so that the screws would not bind.

Hardest thing was to take all the the items and food off the shelf... Unscrew the old rails and screw on the new ones.... Put all that stuff back on the shelf.

Was Very Easy to Insert Glass .. Service was Excellent .I Definally would recommend and use this company again.