FFTR1621RS0 Frigidaire Refrigerator - Instructions

I unscrewed the old drawer support rail and installed the new one. The phone rep. was excellent. He listened to what I needed, looked up the parts for me, and sent me the correct parts the first time. I think the parts arrived within two days, much faster then I expected. I will be doing business with you again whenever I need parts. Thank you for your excellent service. You exceeded my expectations.

Sincerely,

Rob Ponitz

As others have noted: this is an easy repair. I spent more time clearing all of our containers of yogurt that the actually "repair."

This is a good opportunity to clean the glass shelf and so I did that after removing it. Unscrewed the back support screw, removed old rail, and installed new one. (I just used the old screw as it seemed to be in good shape).

Took longer to clear the top shelf to remove it from the refrigerator to do the repairs. Super easy!

removed shelf. took out screw. replaced support

Very, very easy problem to fix. I took the shelf that the support rails were attached to out of refrigerator. Unscrewed broke piece and screwed in new support rail and simply slid shelf back into refrigerator. Ta~Da! If I can do it, you can do it!

First, remove shelf unit from refrigerator and lay glass side down on a large flat surface. Observe, then pay attention to assembly. Spent more time with this, drinking coffee, and playing with puppy, than the actual repair. Only had to remove and replace two
phillips head screws. Replace deli - meat drawer after shelf unit is in place in refrigerator. Check for clearance for door to close.

I had to tap the screw holes with a 8/32 tap so that the screws would not bind.

The shelf needed to be removed from refrigerator and then remove the screw and pull the rail from the bracket on the opposite end. After installing the new rail it turned out to be a fraction of an inch too long so I had to file the cracket on the shelf which is metal. The rail slipped back in and was perfect. Easy job.

The Hardest Part Was Taking Everything Off The Shelf,Took Old Part Off And New Part Popped In And I Tightened The Screw And That's It Done!Thanks PartSelect!

jump thermostat,fan and compressor came on, ordered thermo from this excllent parts supplier, part came in 4 days later, it was exact replacement, works exactly right!

I took the shelf out and took part off and replaced the new one.

Used wood blocks to raise the door off the lower hinge bracket then unscrewed the suspect hinge. Cut a small shim, two layers of soda can, to place under the lower edge of the new hinge bracket and doubled the washers by using the old one to ensure I had adequate clearance for the door. After a little silicone lube I installed the new hinge bracket. All better now.

Remove the shelf. Removed one screw. Removed old part and inst. new part with the one screw. Reistalled self.

Removed the screw at back of broken rail. Removed the broken rail, replaced with the new rail, replaced the screw. Total repair time, 5 minutes. Took longer to clean the shelf off than to replace support rail

I removed the rack from the refrigerator. Then I used a Phillips screwdriver to remove screw from old part then screwed the on the new part to the rack.