Models > GLRSF236JD2 > Instructions

GLRSF236JD2 Frigidaire Refrigerator - Instructions

Jump to:

All Instructions for the GLRSF236JD2
46 - 60 of 608
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Vicki from Johnson City, TX
Parts Used:
5304464438
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Refrigerator was not cooling
This was a simple job. Raised the flap in the back that houses the compressor, removed the wire that holds the relay, pulled out the old relay and pushed the new one on. Replaced wire holder and that was it. Plugged it frig and freezer is at zero and lower compartment at 35. As easy as brushing your teeth!
17 of 24 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
paul from traer, IA
Parts Used:
5303918277
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers
ice maker would not make ice
un plug fridge. removed ice maker from fridge. loosen 2 mounting screws. lift unit in slots to get over heads of screws. unplug wire harness. remove cover. remove 3 screws from control housing. remove 2 motor mounting screws. unplug motor wires from switches w/needle nose. installation is the reverse. plug in fridge turn on icemaker. takes 10 to 15 min to start to cycle.
easy and cheaper than new fridge or ice maker
16 of 22 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Sophia from San Antonio, TX
Parts Used:
297216600
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers
Defrost function in freezer was not working, while the refrigerating side was warm
1. Turned off and unplugged the refrigerator.
2. Removed the lower back panel inside the freezer with a screwdriver.
3. Unplugged the thermostat. (No tool is needed)
4. Ordered a new thermostat from PartSelect and it arrived in 2 business days.
5. Plugged in the new thermostat..
6. Put the lower back panel inside the freezer with screwdriver.
7. Plugged in the Refrigerator and turned the power back on.
8. It is working again!!!
14 of 16 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Charles from New Orleans, LA
Parts Used:
241885001
Difficulty Level:
A Bit Difficult
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers, Socket set
Original gate broke at the swivel point
I removed the old gate by using a flat head screw driver to pry open mouth. I then removed 2 bolts that held on the cage that hols the ice crushing blades. Then I inserted the new gate and used a screw driver to pry the mouth open again (it was more difficult to insert than remove). I then popped in the new gate and re-assembled the cage. It worked on the first shot with no problems!

This is the 3rd time I have attemped and successfully repaired major home appliances myself after the warrenty ran out. I'm sure I could buy a new appliance for the money I saved.
15 of 19 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Frederic from Daytona Beach, FL
Parts Used:
5304464438
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Refrigerator quit running
I located the part that was the culprit as it had buzzed very much before quitting. This is an easy removal as the part is in a two prong jack and just needs to be carefully removed with the new part inserted back in the jack provided. The refrigerator works fine now, but the run capacitor will still buzz on start up of the compressor. I do hope this is normal in this model? anyway it runs fine mow. Thank you.
22 of 42 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Doug from Folsom, CA
Parts Used:
215846602
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
Fridge side warm. Freezer was ok.
Popped off the front plastic cover on the bottom of the fridge, under the doors. Two screws held the defrost timer on under the front side of fridge (below freezer door). You can't really see the timer except for the adjustment knob that is accessible through a hole. Once the screws are removed, disconnect the wire plug and remove and replaced unit. Works fine ever since.
13 of 15 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Vaughn from Virginia Beach, VA
Parts Used:
218518700
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Socket set
Leak in the water tube elbow
First I remove protection cover,then removed the elbow pressing in on the gray coupling housing at each end of the elbow.Mark each piece of water hose before removing the elbow with marker(black)it helps when replacing new elbow.The new elbow slides on each end of water hose ,connect the end to the hose coming out of the door first. Replace protection cover. No more leak.
13 of 15 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Ann from Marriottsville, MD
Parts Used:
5303289501, 5304411659
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
The plastic that held the drawer in place broke
I called Part Select and ordered a new drawer. They got the item to me within 3 days! I would definitely recommend them to a friend.
12 of 14 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
harry from chapel hill, NC
Parts Used:
218762703
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours
Tools:
Screw drivers
door handle broke off of door
door handle off but 2 screws top and bottom of handle that attach to door remained under top and bottom molding. had to remove molding which was tricky. Held onto door with plastic clips which several broke when trying to get molding off. Figured out I had to tap top molding up to remove. unscrewed pieces of door handle and attached new handle. Had to use contact cement to secure molding to door where clips had broken.
11 of 12 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Robert H. from Grand Blanc, MI
Parts Used:
297216600
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
frezer not staying cold enough to freze newly added product
took the shelves out, unscrewed the rear panel,unpluged the thermistat and uncliped it from the line.Replaced with new thermistat in the reverse order. Before turning the unit back on,allowed the coils to defrost.All of the process was shown in your vidio that I was able to view while ordering the part. Thank you
13 of 18 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Shirley from Trafford, AL
Parts Used:
WFCB, 218762703
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
Broken door handle
I removed the cover from the handle by sliding the top one up and the bottom one down (as opposed to snapping it off). Then I removed the screws that held the old handle in place, put the new one in place and screwed it down.
15 of 24 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Bob from Milton, WV
Parts Used:
241885001
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
housing-crusher was broken
removed ice maker box and disassembled crusher unit on front of box and installed new housing.
12 of 16 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Rebecca from Athens, AL
Parts Used:
241860803
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
ice crusher blades not working
got replacement ice container with ice crusher and dispenser in the door. removed broken one and slid in the new one like a drawer and started crushing ice right away!!
11 of 14 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Cherie from Santa Barbara,, CA
Parts Used:
5303289500, 5303289501, 215124343
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
Storage drawers and lower track had cracked lip
It was a dark and stormy night.....

Husband: AArrgghhh - we need a new refrigerator !!
WIfe: Nope, we just need to fix this one, and I know just how to do it. (partselect.com)
Husband: (of little faith) Fine, miss smartypants, go for it...

0) Wife orders correct parts from partselect.com and they arrive 3 days later.
1) Wife manually removed the two old drawers and the Cover-storage pan (has drawer guides)
2) Wife attempts (unsuccessfully) to remove glass frontpiece from old drawer to put on new one.
3) Husband: "Lemme see that ...
4) WIfer (reluctantly): ...uh.. OK...
5) Husband puts drawer on counter and whacks it with his fist after disloging the front panel with a butter knife.
5) Wife (amazed) wow-nothing broke!
6) Husband repeats process and breaks the second front panel
7) WIfe (silently) Oh darn and shoot
8) Husband (verbally) *&%#!!!
9) WIfe (brightly) That's OK - I can glue it. No Problemo!!
10) WIfe (silently) *&%!!
11) Wife assembles old front panel onto first storage drawer
12) Wife cheerfully glues old front panel #2, prays, then assembles it onto second storage drawer.
13) Wife puts cover-storage-pan in refrigerator and slides top drawer in, noticing more friction and more play than ususal.
14) Wife notices that wheels are not included in the cover-storage-pan
15) Husband: Now we are S.O.L. for sure. We need to buy a new refrigerator.
16) Wife (OK, smugly) repairs herself to the storage shed, where she has cleverly kept the old part, which still has the wheels on it.
17) Wife removes wheels from old part and installs them onto new part without breaking anything.
18) Wife installs both drawers and is inspired to clean out the newly restored refigerator.
19) Husband (amazed) admits that family does not need to buy a new refrigerator after all
20) Teenage daughter emerging from her room in a daze, "Hey, is that a new refrigerator?"
21) Wife makes plans to spend remainder of budget that would be used to buy new refrigerator on pearl ring that she has been coveting.
22) AND THEY LIVED HAPPILY EVER AFTER....
10 of 11 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Thomas from Niceville, FL
Parts Used:
241734001
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
There was a hole in the plastic bin where ice fell through to the freezer.
I removed the screws that held the the ice dispencer from the bin. I than removed three screws from the bottom of the bin. I put the new plastic piece on the end of the spiral piece that
pushes the ice. I inserted the spiral piece back into the hole. I than screwed the ice dispencer
to the bin and re-inserted it back in the refrigerator.
It took me about 5 to 10 minutes. It's really easy!
9 of 9 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the GLRSF236JD2
46 - 60 of 608