FRS22PRCW0 Frigidaire Refrigerator - Instructions

I didn't know the front of the drawer could come off so it was pretty gunked up with dried meat juices that had leaked. The fit was very tight. I had to really work the putty knife to get it between the front and the drawer at the bottom where the catch is. I was afraid I would break or chip the front before I got it off but it handled the pressure pretty well. Had to use some force though. Once I cleaned the front it slid right down and snapped into place.

Removed two screws to get to defrost time pull panel down remove two screws holding time and reinstall

took door off. sanded rusting hinge and greased. installed door hinge washer. I had to install a larger washer over hinge bearing to help support the door where it was rusting. no sweat. works like its new. thanks to you guys for having the parts.

take 1/4 hex screws out clean out dust ,remove old fan blade replace with new install bolts .

We removed the front of the drawer from the old drawer and reinstalled on replacement drawer. It only took about 5 min. to complete. Shipping was Prompt. The person that helped to establish the Part no. was very helpful.

Use small srew driver to take door off and put back on just like the video you supplied on line.

First I removed the old drawer front. When put the old front onto the new drawer I noticed that the two little rubber plugs had nowhere to push into as the holes were not drilled out. I got my portable drill and drilled out the holes, then I slid the drawer front into place snapped it in and pushed in the plugs.

Website was great!

The defrost timer was right in front. 2 minutes and a screwdriver and I had it replaced.

To replace the thermostat, I had to take out the back panel, defrost it and then install the new part. the only problem was that the heatshrink tubing they sent was too large. Otherwise, it worked great.

took 4 screws out of the discharge vent on top of the refrigerator section and unpluged the wiring harness and put the section on the counter and unscrewed the timer and put the new one in and reinstalled the assembly and plugged the Jack and put the 4 screws back in, and rotated the timer and put it on defrost removed the back and check the heaters and drain .

just like the video showed...it was excellent!!!

The job was as simple as could be pry away the old and push in the new.
Only wish I had done years ago. Tthis is a great service to customers.

The repair was very simple, I put the cover trim on the insert panel and installed it into the slot.
This is the second time I've repaired this refrigerator, not bad for a single woman.

I first thought the defroster heater broke - took the back wall of the freezer off and cooling fins were fine. Then took the defroster timer out and opened it up. The contacts were badly burnt so the compressor and fan ran during only part of the cooling cycle. Replacing the timer took less than 5 minutes - turn off the power, remove one screw to take out the control box, cut the ground wire (new timer housing is plastic and does not have a ground connection), remove two screws to unmount the timer, unplug the old timer, plug in the new timer, fasten with two screws, put the control unit in and fasten with one screw, turn power back on.

Looked up troubleshooting info on your web site. Decided to replace the defrost timer. Ordered it using Paypal. Received the Shipment in about 1.5 days in Rural NC. Watched Your Video, cut off power to the fridge, removed the top self and unbolted the panel, removed the defective defrost timer, installed the new one and re-installed the panel and top shelf. Set the timer to defrost to check the operation (looked inside the freezer to see that the defroster was glowing red - it was) waited about twenty minutes to ensure that the fridge started cooling again. Fixed!

it was simple