FGHS2634KQ0 Frigidaire Refrigerator - Instructions

Replaced bad parts with new parts it went easy

Removed the previous water filter. Installed the new water filter.
I then filled a large glass full of water from the water dispenser several times to clear the air from the filter and lines.

Time to install, less than 8 minutes.

Thank you Parts Select!

The bin was easy to install on the door, just lined the bin notches with the door notches , and push down lightly the non is locked in, done

Turn off power. Remove ice tray. Back out the two screws with nut driver and just lift ice maker off screws. Do not bend the water fill tube in the back . Now unplug the wire and remove ice maker .
To replace, match the color of wires on plug. Adjust wires in place and water fill tube and back on to the screws. Hold in place and snug screws. Turn power back on. In 4 to 5 hours your ice will start .
FED-EX UT to MN was 13 days to deliver .

Not knowing the history of the refrigerator/freezer and observing that the icemaker would cycle (ice ejector fingers would rotate when the off/on arm was toggled), I concluded that the water valve must have some hard water scale in it which was causing it to stick. I replaced the water valve and the exact same behavior continued. By elimination, I concluded that the microswitch in the icemaker must be sticking. I removed the icemaker, used a hair blow-dryer to heat/dry out the microswitches and then a little shot of WD-40 on the mechanical arms, switches, and cams fixed it.

Repair man wanted a 130.00 service charge plus parts , With the help of YouTube we did the repairs inhouse , couldn't believe it was that easy. Refrigerator is working like a new one ,our maintenance crew has ice cubes were all happy !

Downloaded a schematic of the ice container. Disassembled the ice container, keeping track of which different type of screws went where. Followed the schematic to ensure proper sequence of blades and spacers. Manually rotated unit prior to installing into the freezer in case of binding. Finished.

But I have back ground mechanical skills, I did see the video one time, and everything went smooth......

Looked it up on how to, follow the video
. Very easy 1-2-3 it was out and new one in..........??.

take the broken one out and replace it with the new one. the service was very good, from ordering the part, when it arrived only one day after I ordered it, it was broken in the delivery, I called them and they had another one on the way by the end of the day. Will continually use parts select for my services

It was real easy took the lines off one by one put them on the new unit one by one same with the three plugs than tighten new unit back on fridge.

Had to disassemble the entire ice maker bucket. Simple and straightforward, didn't need any pictures or reference materials. Just time consuming.

Easy to remove the auger Motor and Solenoid, however, it didn't fix the problem. $300.00 into it I now have to purchase a circuit board for $382.00. Not a happy camper.

replaced bin, very easy. hooked on, as long as hook went behind catch.

Door Gasket: Remove old door gasket by pulling out of the retaining channel. I started from the bottom and worked my way around the the door pushing into the retaining channel making sure there were no gaps and smoothing and pushing with my fingers making sure it was pushed all the way in the retaining channel.

Meat Drawer Rail Right Side: I removed the meat drawer from the shelf and then removed the shelf. I unscrewed the broken rail and replaced with the new rail with the old screw. Reinstalled the shelf and slid the meat drawer back into the shelf.

Easy Peasy