All Installation Instructions for Frigidaire Refrigerator FCRS201RFB2

Customer:: Deborah from Ridge Spring, SC
Parts Used:: 240524102
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins
Tools:: Pliers

Broken blade on fan.

Used needle nose pleirs to slide the old fan off.Then slide the new fan on the spindle.The video really made this easy!

Was this instruction helpful to you?

Customer:: Richard from Clovis, NM
Parts Used:: 297309000, 5308000010
Difficulty Level:: Really Easy
Total Repair Time:: 15 - 30 mins
Tools:: Nutdriver, Screw drivers

Evaporator Fan Motor was making loud rattling sound.

Unplugged freezer from electrical socket. Removed lower trays from freezer. Removed sound proof stripping from sides of back panel. Removed upper, lower and side screws from back, lower panel using No. 2 phillips screwdriver. Disconnected motor wires from quick disconnect power supply. Removed motor bracket from freezer back using nut driver. Removed motor from bracket using same nut driver. Replaced motor and screws in bracket. reattached quick disconnect. Attached fan blade to motor making certain to push blade on shaft securely. Replaced bracket to freezer back. Replaced back cover. Replaced stripping. Plugged into power supply. Total time 15-20 minutes.

Was this instruction helpful to you?

Customer:: ronald from deering, NH
Parts Used:: 5304464438
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

freezer would not freeze longer than one day. after ten years without problem

pulled out freezer, went to floor,reached in next to compressor pulled off clip just like on the video.Pulled off old capacitator took off wire leads.Installed new one. Freezer runs great.Loaded it up with beef pork and venison. No problems.

Was this instruction helpful to you?

Customer:: John W from Gloucester, MA
Parts Used:: 297243800
Difficulty Level:: Easy
Total Repair Time:: 15 - 30 mins
Tools:: Pliers, Screw drivers

broken light switch

Removed 2 screws holding front bottom vent grille. . Through opening behind grille found broken part of switch hanging on wires. Removed wires from switch and fed them out through hole for mounting switch, connected wire and pushed into place. The greatest difficulty encountered was my 82 year old knees.

Was this instruction helpful to you?

Customer:: CRAIG from PRESCOTT VALLEY, AZ
Parts Used:: 297309000
Difficulty Level:: Easy
Total Repair Time:: 15 - 30 mins
Tools:: Nutdriver, Screw drivers

Noisy fan

Remove the cover panel inside the freezer, remove and replace the fan motor (pull fan blades off old motor and push on the new one) and replace the cover.

Was this instruction helpful to you?

Customer:: Joseph from Yulee, FL
Parts Used:: 5304518034
Difficulty Level:: Really Easy
Total Repair Time:: 15 - 30 mins
Tools:: Screw drivers

Coils not Defrosting and stopped freezing

Upluged power pulled freezer out from wall removed the two screws that holds the defrost timer unpluged defrost timer pluged new timer in mounted new timer back with the two screws pluged freezer back in and job was complete. Freezer working fine.

Was this instruction helpful to you?

Customer:: jerry from petaluma, CA
Parts Used:: 5304464438
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

refer quit cooling and so did freezer

I replaced the defrost timer,defrost thermostat,and run cap.as it turned out the compressor went bad. I dont know the model because but the time I got this review I replaced the refer with a knew one . two weeks living out of coolers was so much fun !!!!!!!!

Was this instruction helpful to you?

Customer:: Rusty from Howell, NJ
Parts Used:: 5303918774
Difficulty Level:: Easy
Total Repair Time:: 15 - 30 mins
Tools:: Nutdriver, Socket set

Fan would stop or turn slowly. outside of refridg hot

took off cardboard removed two screws holding fan housing. Removed new fan and housing from box and mounted new fan to new housing (two screws). Installed new fan and housing. reinstalled cardboard and plunged in power cord. Perfect fit.

Was this instruction helpful to you?

Customer:: Michael from Rockford, MI
Parts Used:: 5303918774
Difficulty Level:: Easy
Total Repair Time:: 15 - 30 mins
Tools:: Socket set

Rattling Noise from behind frig

Initially, I traced the noise down to the evaporator motor area. I thought it was the fan blade so I ordered and changed it. Noise level better but still not good. Then I ivestigated problem area again. Removed the motor,discoverd that the motor shaft was loose /drifting which caused the "hummm" and uneven fan blade rotation. Orderd and installed new motor and all is good.

Was this instruction helpful to you?

Customer:: Gary from Hudson, FL
Parts Used:: 5304464438
Difficulty Level:: Really Easy
Total Repair Time:: 15 - 30 mins
Tools:: Screw drivers

not cold enough

per the video..easy installation....unfortunately the temperature did not improve. We still have a refrigerator temp in the upper freezer.....and a "cooler" in the refrigerator section

Was this instruction helpful to you?

Customer:: FRANK from BRADENTON, FL
Parts Used:: 5304464438
Difficulty Level:: Really Easy
Total Repair Time:: 15 - 30 mins
Tools:: Nutdriver

Frige and freezer not cooling

I should have ordered start kit instead of start capacitor. The start cap astir did not fix problem so I ordered kit. Compasator comes as part of kit. Followed enclosed instructions. Cut existing wires and reconnected new wiring. Simple as that. It's a plug in item. Now worried it may be working to good. Freezer down to 10 deg. Watching to see if compressor is running to long. Seems ok lol. Wife hates me now. She wanted new frige.

Was this instruction helpful to you?

FCRS201RFB2 Frigidaire Refrigerator - Instructions