FRS22PRCD1 Frigidaire Refrigerator - Instructions

Got the new one and took the face plate off the old and sliped it right on to the new one. I noticed that the guide edges on the new Drawer are made better. That is added bennie.

Thank you so much

First we took the the old drawer out and pride off the front clear covering on both sides. Then we placed the front covering on the new drawer and fit it in place. This had to be done twice since it did not take the first time. It had come loose after a couple of days and we snaped it back into place. It has done fine since.

I received the drawer within 2 days of ordering it online, which was extraordinary. I removed the front of the old drawer, as instructed and placed it on the new drawer. I then replaced the drawer in the refrigerator and the job was complete. The entire experience from beginning to end was simple and completed in very little time. Had I known it would be this easy, I would have ordered the drawer sooner.

I didn't know the front of the drawer could come off so it was pretty gunked up with dried meat juices that had leaked. The fit was very tight. I had to really work the putty knife to get it between the front and the drawer at the bottom where the catch is. I was afraid I would break or chip the front before I got it off but it handled the pressure pretty well. Had to use some force though. Once I cleaned the front it slid right down and snapped into place.

Used Old Screws And a nutdriver

We removed the front of the drawer from the old drawer and reinstalled on replacement drawer. It only took about 5 min. to complete. Shipping was Prompt. The person that helped to establish the Part no. was very helpful.

Use small srew driver to take door off and put back on just like the video you supplied on line.

Removed two screws to get to defrost time pull panel down remove two screws holding time and reinstall

took door off. sanded rusting hinge and greased. installed door hinge washer. I had to install a larger washer over hinge bearing to help support the door where it was rusting. no sweat. works like its new. thanks to you guys for having the parts.

take 1/4 hex screws out clean out dust ,remove old fan blade replace with new install bolts .

First I removed the old drawer front. When put the old front onto the new drawer I noticed that the two little rubber plugs had nowhere to push into as the holes were not drilled out. I got my portable drill and drilled out the holes, then I slid the drawer front into place snapped it in and pushed in the plugs.

Website was great!

The defrost timer was right in front. 2 minutes and a screwdriver and I had it replaced.

To replace the thermostat, I had to take out the back panel, defrost it and then install the new part. the only problem was that the heatshrink tubing they sent was too large. Otherwise, it worked great.

took 4 screws out of the discharge vent on top of the refrigerator section and unpluged the wiring harness and put the section on the counter and unscrewed the timer and put the new one in and reinstalled the assembly and plugged the Jack and put the 4 screws back in, and rotated the timer and put it on defrost removed the back and check the heaters and drain .

just like the video showed...it was excellent!!!

The job was as simple as could be pry away the old and push in the new.
Only wish I had done years ago. Tthis is a great service to customers.