Models > ACG150NCW0 > Instructions

ACG150NCW0 Frigidaire Refrigerator - Instructions

Jump to:

All Instructions for the ACG150NCW0
46 - 60 of 60
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Gregory from Alexandria, MN
Parts Used:
3206166, 3206165
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
I inherited this old refrigerator as part of the space where I now live. I found the bottom shelf bar for the door tucked away under the sink, but there were no brackets. I'm sure they were broken and discarded at some earlier time.
I snapped the brackets into the ends of the shelf bar, then inserted them into the holes in the door and pulled down each end until it snapped in place.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Mary from Turlock, CA
Parts Used:
5303324302, 3206150
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers
The end caps for the door shelves had broken
The repair was very easy. I had to squeeze the ends of the door shelf in a bit with pliers since the shape of the new end caps was slightly smaller than the shelf bar. BUT - here is the most important part. I had gone to a parts replacement store where I was quoted the price of $18.00 EACH for the end caps. Yes, $18.00 each!! With PartSelect, I paid less than that for the 2 caps including shipping - $15.42 total. Thank you, PartSelect.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Wylie from Houston, TX
Parts Used:
3206166, 3206165
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers
End cap clips broke
You just slide off the broken part and replace it with a new part. I had to make a slight adjustment to the end of the shelf rail to allow the new piece to properly mate with the old shelf rail.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Susan from Rapid City, SD
Parts Used:
218906802, 316538904
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
My Frig Light Stopped
I am a 65 year old woman with no mechanical aptitude: I just unplugged the frig. And used a screw driver to pry of the plastic socket from its outside edge. . Then you just unplug two tiny contact plugs that appear when you pull out the socket and replug in those two the same way on the new part. Pop the socket back into the hole . . . . And screw in the new bulb. I knew I needed the socket part cause when the bulb burned out , a new bulb still did not work. . . If I can do it, anyone can!
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the ACG150NCW0
46 - 60 of 60