PLRU1777DS0 Frigidaire Refrigerator - Instructions

I just put it in place and it was perfect. I want to say this company has the fastest shipping ever and the part they sent was exactly what I needed.Thank You!

Very simple. I retrieved the Model number, got on your website and typed it in along with other required information. The page lead me directly to the part I needed. No tools were required because it is a snap-on piece that broke. The shelf snapped on and Voila! The repair was complete.

the part I received was exactly right - just snapped it on to the shelf.

Had my 3 year old remove the 4 screws to holds the carboard in place. Pryde the old fan blade off with a screwdriver. slid the new fan blade on to the shaft then my 3 year old put the screws back in.

When i found out there was no thread in brace where bolts were supposed to screw in, I panicked. I thought I would have to send part back or go to a machine shop to make a thread. I called a friend for help and he told me the bolts would make the thread if I just screwed them in. Sure enough, the bolts made the thread and then I just proceeded to instal motor and put refrigerator back together. It was simple.

I first noticed my ice cream getting soft. Then 2 days later the alarm went. I emptied the freezer, opened the panels and saw no frost. I saw that 99% of issues were resolved with a defrost timer and thermostat so I ordered those. I have to say the parts came quickly and they went in very easy. My freezer seems to be in the 1% category though. It's still not cooling even though I can measure the temperature at the front of the evaporator coil is cold but by the end of the coil it's almost room temperature. I think a repairman is called for.

Removed old fan motor and installed new one.Not much room for big hands back there.Flexible extensions valuable on this job.

Remove the cover panel inside the freezer, remove and replace the fan motor (pull fan blades off old motor and push on the new one) and replace the cover.

I unscrewed the screws that held the old fan on, disconnected the wiring harness and removed the old fan. I pulled the blades off the motor and put it on the new fan. One thing of note, the screw holes on the new fan weren't threaded. I assume this is by design, so I used the screws to thread the holes before installing it in the freezer. Once I did this, the rest of the installation was easy, just screw it back in and connect the wiring harness.

Just took old knob out put new knob in real easy thank you jd

Initially, I traced the noise down to the evaporator motor area. I thought it was the fan blade so I ordered and changed it. Noise level better but still not good. Then I ivestigated problem area again. Removed the motor,discoverd that the motor shaft was loose /drifting which caused the "hummm" and uneven fan blade rotation. Orderd and installed new motor and all is good.

took off cardboard removed two screws holding fan housing. Removed new fan and housing from box and mounted new fan to new housing (two screws). Installed new fan and housing. reinstalled cardboard and plunged in power cord. Perfect fit.

Wasn't hard after I got the right part. Both left and right are decribed on order page as 42 and of course I order the (right)wrong side. Had to reorder (left)and got the correct side. Since the left side disintergated, I decided to keep the right side and replace both sides. Replacing was pretty much a breeze. Recently had to order a door shelf also. Replaced it in less than a minute. Delivery on these parts were great. Here in a matter of two days. Thanks parts replacement guys.

Ordered the part....arrived in less than 2 days and 2 minutes later...the salad dressing was back in its designated spot!!!

Simple drop-in. No tools. Less than one minute "repair" time. Worrying that the glass would break en route was for not; huge box with lots of peanuts and bubble wrap prevented any potential breakage. Very satisfied with price, shipment (including time), and overall "repair".