Models > ACG130VNCW0 > Instructions

ACG130VNCW0 Frigidaire Refrigerator - Instructions

Jump to:

All Instructions for the ACG130VNCW0
31 - 42 of 42
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Gerald from Goldsboro, NC
Parts Used:
5303917590
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Wrench set
Deforst Drain Pan rusted out
The old drain pan had a 1 ½” tall bushing attached to the center of the pan. The new pan did not have this bushing which was great. I had to cut about 1 inch off the bushing to remove the old pan. Also after cutting the bushing I had to screw the bushing off after cutting the old pan from the bushing. I installed new pan onto the ½” of threads that was left on the top of the compressor. Checked repair two days later all was great.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Wylie from Houston, TX
Parts Used:
3206166, 3206165
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers
End cap clips broke
You just slide off the broken part and replace it with a new part. I had to make a slight adjustment to the end of the shelf rail to allow the new piece to properly mate with the old shelf rail.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Ingrid from Fitzgerald, GA
Parts Used:
5303324302, 3206150
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
shelf end caps both broke and the rack came off
inserted shelf caps into rack strip then into openings and hit them with my fist (gently) till they 'seated' and locked
Was this instruction helpful to you?
Thank you for voting!
Customer:
Rochelle from Big Lake, MN
Parts Used:
5303324302, 3206150
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
door shelf end cap hooks broken
Previously I glued them on with epoxy and Taped them. Often redoing. So I needed to clean the surface with goo gone. And to clean out the slots I used a utility knife. I had a small bump on the new end cap so I removed it with the utility knife. Simply put the end caps on the rail on each end. Then put the hooks in the slots and slide downward until it is secure. I should have thought of parts before! When the rail broke off I had cherries in a jar on that shelf. It crashed to the floor. I had a sticky mess every where.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the ACG130VNCW0
31 - 42 of 42