MRS22HRAW0 Frigidaire Refrigerator - Instructions

All I had to do was remove the original support that was on the inside wall of the refrigerator, which I had to use pliers since there were broken pieces, and then I just snapped the new one into the three holes provided for this support. The crisper drawer works fine now. It literally only took about 1 minute.

Based on the website I decided it was most probably the defrost timer, and that was correct. I ordered it, watched the video, and two days later the part was at my door. Took the nut driver, removed 4 screws, then removed the old defrost timer, installed the new one, re-installed the whole plastic assembly with the four screws, and done!!! Couldn't have been easier.

Put the end caps on the metal bar and put it on the freezer door and it snapped right in.

Very easy to do in less then 4 minutes to do both shelves.

Thank you very much.

I watch the how to repair video on line and the repair went very quick and easy.It was just like the video,no hidden suprises.

I used a small screwdriver to pry the tabs of the front glass panel loose, and then slid it upward and out of the broken storage drawer. Then I slid the panel into the front slots of the new drawer and pushed in an evenly downward manner until it snapped in place. It was an easy task and now we have a new drawer that slides smoothly.

Removed old pan and cleaned all surfaces and reinstalled new pan.

Found the part on this site ordered and received part in 3 days. Took approx. 10 min to replace. Thanks for the quick service.

Unplugged fridge, opened the door, used flat head screwdriver to pop off old switch, unplugged wires, plugged in new switch, popped it back in, and plugged the fridge back in. 2 minute fix.

A little research told me the hum plus no cooling was either the compressor or the relay. I ordered the new relay and put it in but it didn't fix the problem. I ended up having to buy a new fridge, but it was worth the $30 gamble to see if I could fix it on the cheap and it saved me the money a service call would've cost. Pretty easy installation, just in a tight space on my model.

Removed the broken drawer and Sfelf. Removed drawer front and attached it to new drawer part, Removed parts from shel fand reaattached to new shelf and installed both new parts. Couldn't have been any easier. Parts were great.

The old drawer front needed to be carefully pried off with a plastic bladed screwdriver. The front simply slides onto the new drawer and is tapped into place with a rubber mallet.

Most impressive was the literally one-day standard (not overnight) delivery!

I removed the old drawer. Next I popped off the drawer front and threw away the rest. The drawer front then snapped neatly onto the new storage drawer. I then slid the newly assembled drawer into place.

Ordered a new defroster timer and replace old one. It works just fine. A $35 repair vs a $500 new appliance.
Cool.
GWE

Took the front panel off the old drawer and put it on the new drawer.

couldn't have been easier, even an old lady (like me) can do it with no problem.

First of all, I both called and e-mailed PartSelect, to praise them for my overall experience. It's a 17+ year-old refrigerator, they had the parts in stock, I ordered them, and received them the next day; less than 24 hours later. WOW! The install was a bit tricky, just trying to get the old drawer fronts removed, to put onto the new drawers. I was careful to not manhandle them too much, so as not to break them. They were just kind of gunked up with debris, from the many years of use. I used the screwdriver blade to gently pry the drawer front loose, from the old drawer. Once loose, the reinstall was really quite simple. Thanx!