WRS22PRBW1 Frigidaire Refrigerator - Instructions

The end cap is easy to remove and replace. The personnel at PartSelect was extremely helpful in re-ordering the correct part.

I removed old drawer, removed face plate, installed faceplate on new drawer. Test OK.

No tools required! Easy as falling off a log! Drawer face snaps off and reinstalls on new drawer body; slide it in track and you're good to go.

My husband just dislodged the front of the old drawer and very carefully slipped it into the new drawer. Presto all fixed. Very easy. So happy with the new drawer that is so easy to slide open. We had taped the old one for quite a few years. Wish I would have thought of looking up this web-site earlier! Thank you so much for this new drawer!!

Lower Door in Fridge Broke and all the Meats and Cheeses came tumbling out...Bulldog grabbed a bunch of it and gobbled it down ...so I looked up the part on Wednesday and ordered it, received it on Friday (really fast without paying extra)...took out meat and cheese that was left, presssed old front piece onto new drawer and slid it into place...meat and cheese now safe from bulldog again!!! Thanks PartSelect.com!

First we took the the old drawer out and pride off the front clear covering on both sides. Then we placed the front covering on the new drawer and fit it in place. This had to be done twice since it did not take the first time. It had come loose after a couple of days and we snaped it back into place. It has done fine since.

I received the drawer within 2 days of ordering it online, which was extraordinary. I removed the front of the old drawer, as instructed and placed it on the new drawer. I then replaced the drawer in the refrigerator and the job was complete. The entire experience from beginning to end was simple and completed in very little time. Had I known it would be this easy, I would have ordered the drawer sooner.

removed the drawer, pried off the glass front, slid the glass front into the new drawer, and returned the drawer to its place in the referigerator.

The schematic drawings on the PartSelect website were really helpful.

Got the new one and took the face plate off the old and sliped it right on to the new one. I noticed that the guide edges on the new Drawer are made better. That is added bennie.

Thank you so much

First I removed the old drawer front. When put the old front onto the new drawer I noticed that the two little rubber plugs had nowhere to push into as the holes were not drilled out. I got my portable drill and drilled out the holes, then I slid the drawer front into place snapped it in and pushed in the plugs.

Removed two screws to get to defrost time pull panel down remove two screws holding time and reinstall

take 1/4 hex screws out clean out dust ,remove old fan blade replace with new install bolts .

Website was great!

The defrost timer was right in front. 2 minutes and a screwdriver and I had it replaced.

To replace the thermostat, I had to take out the back panel, defrost it and then install the new part. the only problem was that the heatshrink tubing they sent was too large. Otherwise, it worked great.

just like the video showed...it was excellent!!!

took 4 screws out of the discharge vent on top of the refrigerator section and unpluged the wiring harness and put the section on the counter and unscrewed the timer and put the new one in and reinstalled the assembly and plugged the Jack and put the 4 screws back in, and rotated the timer and put it on defrost removed the back and check the heaters and drain .