FFSS2615TS3 Frigidaire Refrigerator - Instructions

I broke off remainder of clip, and used phillip
screwdriver and pushed pin into wall. I lined up new support and pushed in peg to secure

slid the shelf in place

Took out old frame by removing drawer then lifted frame out. Lifted glass panel out of frame, place glass panel in new frame, places frame back in refrigerator and slid drawer back in. Easiest repair ever and I repair nothing myself!

Inserted unit

great push old in came out and push new one in

Removed all items from glass top then removed drawer from frame. Removed damaged frame. Transferred glass top to new frame and installed new frame. Reinserted drawer. E Z P Z

removed broken one and slid in new one, put in glass.

Removed and inserted new. Easy peasy

Unscrewed old bulb and put in new one

I emptied freezer side of unit, turned unit off, rolled unit away from wall, unplugged unit, turned ice maker water supply off, and took out the ice maker. I then took out old light and replaced it with new light. I then plugged in the unit, turned on the water supply, rolled the unit back in place, placed the ice maker back in the unit and turned the unit back on.
After two hours I placed the frozen items back in the freezer.

I ordered a replacement ice/water dispenser module from partselect.com using my model number. The correct color of grey was available. First, turn off power to the fridge. There are 3 number 2 phillips screws under the drip tray that mount the facing to the refrigerator. Remove those screws and gentle lift up on the facing to remove it from the slots that hold the top of it to the fridge. Unplug the cable and set the facing aside. Locate the power plug for the ice dispenser module. It should be to the left of the module. Remove the 3 screws that hold the module to the fridge and unplug. Gently pull foward to release the module from the fridge. Once it is free, push the water dispenser tube out towards the fridge doing so from the dispenser handle side until the tube frees from the old module(this is the hardest part to achieve but doable). Repeat the process in reverse to install the new module. This took me 15 minutes to remove and install the new one.

Ice was not dispensing. Examined the ice bin and auger, noted that the plastic ring that holds the auger at the front of the bin was broken all the way around. Pulled out old bin, making sure the ice fill level was raised all the way up, and pushed in the new bin. The new bin filled with ice, which promptly turned into a solid mass of ice because the ice maker was also faulty. I replaced that as well and have not had any issues.

Just popped it in.

I just slipped it into place.

Not knowing the history of the refrigerator/freezer and observing that the icemaker would cycle (ice ejector fingers would rotate when the off/on arm was toggled), I concluded that the water valve must have some hard water scale in it which was causing it to stick. I replaced the water valve and the exact same behavior continued. By elimination, I concluded that the microswitch in the icemaker must be sticking. I removed the icemaker, used a hair blow-dryer to heat/dry out the microswitches and then a little shot of WD-40 on the mechanical arms, switches, and cams fixed it.