LGHK2336TD5 Frigidaire Refrigerator - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- James from ORLANDO, FL
- Parts Used:
- 241829001
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
ICE WOULDN'T DISPENSE FROM ICE BOX
I read other suggestions trying isolate auger motor shaft with pliers while turning bar drive. needle nose pliers could hold the shaft. bar drive just would spin. so took the whole ice box assembly out
(only 2 screws) and with a metal cutting blade used the sawzall to cut along the shaft. freed it up enough to then unscrew it from that point. Left handed threads by the way.
(only 2 screws) and with a metal cutting blade used the sawzall to cut along the shaft. freed it up enough to then unscrew it from that point. Left handed threads by the way.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Michael from FREE SOIL, MI
- Parts Used:
- 243297613
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers, Socket set
Original ice maker not working leaking water water out door
Removed exterior housing, sliding old unit forward to release. New unit went in easily. Caution wires don't get pinched.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Mayra from VALLEY STREAM, NY
- Parts Used:
- 240351061
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
BROKEN DRAW
Remove old one and put in the new one
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- ruth from vancouver, WA
- Parts Used:
- 242252702
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Nutdriver
ice maker not making ice
The part was easy to install and solved the problem! We had ice within hours. Thanks PartSelect!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- William from DUCK RIVER, TN
- Parts Used:
- 242252702
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Nutdriver, Pliers, Screw drivers
Water line retainer missing in one port of new valve
carefully removed retainer from old valve
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Daune from OCALA, FL
- Parts Used:
- 241675704
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 1- 2 hours
- Tools:
- Screw drivers
Ice Maker was making ice erratically
After sending PartSelect the info to their troubleshooting dept. about my ice maker, they recommended replacing the ice solenoid. I did so at a cost of $102. No change, turned out replacing the ice maker(did not purchase from PartsSelect) was the issue and works fine now.
So wasted $102. FYI the part took 6 days to arrive.
So wasted $102. FYI the part took 6 days to arrive.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- kelly from Comfort, TX
- Parts Used:
- 241993001
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers
shelf supports broke
just slid them in and gently taped the pegs in
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Samuel from Camden, SC
- Parts Used:
- 241993101
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers, Screw drivers
Broken shelf support stud
Use pliers to remove the broken support. Clear the remaining insert pieces with screwdriver/pliers and insert the replacement part.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- mark from jonesboro, GA
- Parts Used:
- 241993101
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers
Broken tabs
The tabs were broken by kids it took 10 minutes to repair on all 4 tabs you have to remove the push pins completed to get the new tabs to fit right
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Pat from FORT MOHAVE, AZ
- Parts Used:
- 241514601
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver
Left glide for center shelf broke on front corner so the shelf lost support.
Unscrewed bolts, removed broken part and replaced with new glide. The part was slightly longer than original so I had to pound it in a little which slightly bowed the new part, but it works.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Joseph from Florence, CO
- Parts Used:
- 241993101
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers
Drawers wouldnt open
Replaced wall pins pulling center pins removeing set new ones replaced drawers. Damm Kids Busted the old ones it was easy to find your web site , parts and purchasse items as this was a new one It was diffacullt to use drawers
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jimmy from west sayville, NY
- Parts Used:
- 242252702
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers, Wrench (Adjustable)
Refrigerator wasn't "winterized" ..This is a summer home, the cold winter cracked the water valve
I put the new unit up to the old one to see exactly how it goes, took the 2 screws holding the unt off...Took the 3 water lines off with adjustable wrench, put back exactly the same way and it worked with no leaks
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Lynn from NESCOPECK, PA
- Parts Used:
- 240351061
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Cracked crisper
Pulled out the old-put in the new.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Gail from TIGARD, OR
- Parts Used:
- 240599803
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
The frame on my meat pan cover broke.
I removed the old frame and the glass. I put the glass in the new frame and inserted the frame & glass in the shelf brackets. No tools required. Nothing difficult or tricky about the replacement and installation.
It took longer to remove the items from the shelf than to replace the new frame and glass.
It took longer to remove the items from the shelf than to replace the new frame and glass.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Suzanne from TAVARES, FL
- Parts Used:
- 240599803
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 15 - 30 mins
broken shelf holder
You pop the old frame out, take out the glass, slide the new frame in and reinstall the shelf. No tools required. Very easy.
Was this instruction helpful to you?
Thank you for voting!