EI23CS35KS6A Frigidaire Refrigerator - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Donald from WEIRTON, WV
- Parts Used:
- 241885001
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers, Socket set
Plastic gate to redirect ice to the crusher broken off
Removed ice maker bin...removed screws and housing and reinstalled all...very easily completed.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- John from BROWNSBURG, IN
- Parts Used:
- 5303918344
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver
Unit Would No Longer Eject Ice Cubes
Holding down the power button for 15 seconds would no longer advance the ice maker, so apparently the motor had burned out. I removed the two screws at the back of the unit and unplugged it. Plugged the new one in, replaced the two screws and turned the power on. Simple as that! Started producing ice a short time later.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Mitchell from FOXWORTH, MS
- Parts Used:
- 242252702
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Wrench (Adjustable)
I let value was leaking its self
Undo a few bolts unplug power and unhook water lines then recut all lines and push in to new value
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- David from Lehman, PA
- Parts Used:
- 5303918344
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver
The icemaker was making a clicking noise. The paddle that moves to let the ice drop into the ice container had trouble moving the new ice so it could retract.
This was one of the easiest repairs I ever did. All that is needed is a nut driver. Turn off the freezer. Remove the ice container. The two screws that hold the ice maker only have to be loosened since the mounting holes are keyhole shaped. Loosen the screws, slide the icemaker up, unplug it, and remove it. Plug the new one in, place it over the scews, drop it in place and tighten the screws. Replace the ice container. Turn on the freezer. Turn on the ice maker, run it through a cycle, and job is complete. Took about five minutes, start to finish. The water doesn't have to be turned off since there is no direct connection to the ice maker.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Lawrence from HUNTINGTON, IN
- Parts Used:
- 240396002
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Screw drivers
Filter would not seat without releasing itself.
Following previous installation instructions was very useful. Would add that the nut driver needs to be 1/4 in and to release the water lines from the valve body, simply squeeze the blue ring toward the valve and pull on the water lines at the same time. Simple fix!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Rebecca from Sapulpa, OK
- Parts Used:
- 242252702
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Wrench (Adjustable)
Water began to leak from valve
We followed the online instructions and tah-dah it was working...
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Alvin from Barbourville, KY
- Parts Used:
- 242252702
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Screw drivers
left out in the cold an froze
remove the old one and replace with the new one and yes it was that easy. All of the lines and wiring connectors were color coded
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Thomas from FONDA, NY
- Parts Used:
- 241547902
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
No light in fridge
I first ordered the wrong switch I called and got a return label and was refunded my money before even shipping the wrong switch I was helped for the right switch and it arrived in 5 days the replacement works perfectly very easy to install. Thank you
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Judy R. from MOORESBURG, TN
- Parts Used:
- 5303918344, 241691701
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Nutdriver, Socket set
Remove the previous ice maker and install the new one
The repair was fairly straightforward now that we realized the ICE CREAM SHELF also needed to be replaced. It is strongly advised that your instruction as to that fact should be in bold, ALL CAPS, or a different-colored type. I believe this is the 3rd time we have ordered the ice maker from you and we HOPE that you have appropriately refunded our account for the one that you received back on 1/27/21.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- LAVAUGHN from MIAMI, FL
- Parts Used:
- 5304512686
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Nutdriver, Socket set
Installed new inverter
Secured bracket. Attached electrical contact to the compressor. Secured inverter to bracket.
Problem: the electrical contact cords are very short, therefore it wa difficult to reach the compressor. Even after connecting to the compressor, the cords are under stress.
However, the refrigerator is working fine.
Problem: the electrical contact cords are very short, therefore it wa difficult to reach the compressor. Even after connecting to the compressor, the cords are under stress.
However, the refrigerator is working fine.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Joe from Pittsburg, PA
- Parts Used:
- 242252702
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Nutdriver, Socket set, Wrench set
Leaking Water Vlave
Just follow the instruction that come with the valve. Easy.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Susan from BRAINTREE, VT
- Parts Used:
- 218755402
- Difficulty Level:
- Very Difficult
- Total Repair Time:
- 1- 2 hours
A set scew was ordered twice.
The first order arrived in a huge box and there was no scew to be found, the box had wholes in it. I was given a refund and told to order again.
The repair did not happen and the set screw which was actually recieved the second time was returned because it was the wrong size.
The repair did not happen and the set screw which was actually recieved the second time was returned because it was the wrong size.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Steve from Lakeland, FL
- Parts Used:
- 240350649
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Glass Shelf Insert shattered in my hand while I had it out cleaning it.
Simply replaced the glass shelf. Fit was finish were great.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Enrique from Harpswell, ME
- Parts Used:
- 242252702
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver
ice maker wasnt making ice
Water was leaking so I replaced the entire valve and just followed the color codes and thats it. Plug and play.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Leon from Mission Viejo, CA
- Parts Used:
- 242252702
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver, Wrench (Adjustable)
Ice maker failed to make ice
Removed lower cardboard cover, shut off water supply valve, unpluged frig. Used wrench to remove 3/8 water line from water valve, removed electrical connectors from solenoids, used fingers to unscrew water connections from valve.
Was this instruction helpful to you?
Thank you for voting!