FPSC2278UF8 Frigidaire Refrigerator - Instructions

We followed the online instructions and tah-dah it was working...

Replacement of the water valve repair was a snap. Only the main supply line needed to use a nut to secure the water supply. All other lines were simply cut below the pointed end of the plastic tubing line, nylon nut discarded and simply pushed in to seat with a O-ring fitting. Took no more than 10 minutes to install the new valve and test for leaks after turning water back on. This was the easiest appliance repair I have done in > 5 years, 100% success first time,

Tried JB Weld, not sufficient.

Got online, looked at the parts fiche for my model, chose the crisper top frame. Wrong part. Sent it back (shipping as $60 on a $125 part).
Ordered the part that the wheel appears to be screwed into (described as crisper support frame. Ordered new $11 plastic wheel as well.

Wrong part. It appears that the crisper drawers on my unit are supported by a monolithic piece (solid plastic) that includes the frame as well as the locators for the wheels. I could send pictures, but have decided to abandon fixing it. (I tossed the metal support that was the second order into the trash ($60 part)....

Installed new support

had to remove broken by pushing 1pin then remove.
put new one in reset pin done.

The video was very helpfull. They were fixing the same refrigerator that I have. I punched in the set pin on the old part. Removed the old part by prying it out with a putty knife. Inserted the new part and drove in the set pin. I was glad that PartSelect had my parts. The repair shop in Fort Wayne Indiana did not even show this repair part on their computer.

remove the old one and replace with the new one and yes it was that easy. All of the lines and wiring connectors were color coded

The first order arrived in a huge box and there was no scew to be found, the box had wholes in it. I was given a refund and told to order again.



The repair did not happen and the set screw which was actually recieved the second time was returned because it was the wrong size.

just replaced the old broken one and put the drawer back .

Simply replaced the glass shelf. Fit was finish were great.

Nothing exciting - just replaced the defective drawer covers with the new parts. The guides are poorly designed. the bottom guides on both covers failed.

took the back off refridgerator, disconnected water valve assembly, then disconnected water lines and electrcal connectors. also i received the part in less than 24 hours

The old pins have to be completely dislodged (preferably with an awl) before placing the new crisper support. The new pin of the support should be driven easily into the hole on the refrigerator´s wall with a conventional hammer (carpenter type). If you find resistance while hammering on the pin, do not continue. This probably means that the old pin is still inside the hole and does not allow the new pin to go in.

removal of the old valve to identify the problem took the most time. Once the new valve came it it was easy. NOTE: the old one had threaded connectors, and the new one is press/fit so the ends of the tubing need to be cut. The color coding and size matching are great.

Pried the broken support insert out with a screw driver and pulled it out with pliers, then inserted the new and pressed it in and Presto the drawer now works good again.