Models > TS25AGXRD00 > Parts

TS25AGXRD00 Estate Refrigerator - Parts

Jump to:

61 - 72 of 287
Keep searches simple, eg. "belt" or "pump".
This part is the top hinge for your refrigerator door. It is made of metal and is approximately 5 inches by 3 ¼ inches in size. This hinge is for the right side of the refrigerator door only. The left...
In Stock
Order now and your part arrives by Apr 23
In Stock
Order now and your part arrives by Apr 23
This part may come with a plastic or metal auger depending on the factory. It will work with your appliance if found with the model number. (Make sure you install properly at back of ice container, be...
In Stock
Order now and your part arrives by Apr 23
This OEM hinge kit includes the lower left and right hinges for both the refrigerator and freezer doors. It helps the doors open and close smoothly, stay aligned, and seal properly. Compatible with ma...
In Stock
Order now and your part arrives by Apr 23
This kit no longer includes the connectors. It is only the tubing/water reservoir. Note: This tubing requires an adapter coupler (PS369735) to take the tubing from 1/4 inch to 5/16 inch.
In Stock
Order now and your part arrives by Apr 23
This clip is sold individually.
Special Order
This dispenser door pin comes with the washer.
In Stock
Order now and your part arrives by Apr 23
This door gasket is used to seal the freezer door when closed.
In Stock
Order now and your part arrives by Apr 23
Support wheel assembly with bracket. Kit of 2.
No Longer Available
The heater is located at the bottom of the evaporator. The defrost heater heats the evaporator in the defrost mode of operation. The thermostat must be replaced when replacing the defrost heater.
In Stock
Order now and your part arrives by Apr 23
This is a kickplate, but you may also know it as a grate or a grille. It is a part for your refrigerator. The purpose of the kickplate is to allow air to circulate by flowing through the grates and in...
In Stock
Order now and your part arrives by Apr 23
This part strips ice from the icemaker mold during the ejection cycle to prevent ice pieces from falling back into the mold.
Special Order
61 - 72 of 287