Models > EI23CS35KS3A > Instructions

EI23CS35KS3A Electrolux Refrigerator - Instructions

Jump to:

All Instructions for the EI23CS35KS3A
121 - 135 of 304
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Craig from BRIDGEPORT, NE
Parts Used:
241885001
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Installation of Frigidaire Housing crusher assy.
I followed the YTube video. The ice maker doesnot crush ice. The auger moves the ice to the dispenser. Is there a position for metal blades when assembling auger?
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Daune from OCALA, FL
Parts Used:
241675704
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours
Tools:
Screw drivers
Ice Maker was making ice erratically
After sending PartSelect the info to their troubleshooting dept. about my ice maker, they recommended replacing the ice solenoid. I did so at a cost of $102. No change, turned out replacing the ice maker(did not purchase from PartsSelect) was the issue and works fine now.

So wasted $102. FYI the part took 6 days to arrive.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Ray from PADUCAH, KY
Parts Used:
241885001
Difficulty Level:
Very Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Pliers, Screw drivers
ice maker stoped crushing ice
i watched the video very simple repair
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Craig from AIKEN, SC
Parts Used:
241684503
Difficulty Level:
Very Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Pliers, Screw drivers
Ice was not allowed to be dispensed because of worn part on auger.
Followed instructions in video that was suggested when I placed the order.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
ruth from vancouver, WA
Parts Used:
242252702
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver
ice maker not making ice
The part was easy to install and solved the problem! We had ice within hours. Thanks PartSelect!
2 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Wes from FARMINGTON, NM
Parts Used:
5303918214
Difficulty Level:
A Bit Difficult
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver
Refridgerator too cold...freezing food,could not turn down
First,read "how to" on the internet because the thermostat comes with no instructions and unplug refer. Second, remove food and lower rear panel. Third, pull off thermostat from tube it clips to, unhook wire harness,and cut wires.Fourth,add heat shrink tubing from store(that supplied is way too big) and connect wires with automotive connectors;shrink-seal tubing with flame.Fifth, re-install everything, and replace food.Sixth,use a thermometer to check temp and adjust controls as needed.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
William from DUCK RIVER, TN
Parts Used:
242252702
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Pliers, Screw drivers
Water line retainer missing in one port of new valve
carefully removed retainer from old valve
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
James from SEMINOLE, OK
Parts Used:
5303918214
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Screw drivers
refrig.freezing up.
I followed the instruction video.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
shirly from FRAZIER PARK, CA
Parts Used:
5303918214
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Screw drivers
cold freezer warm refridgetor
removed lower panel in freezer, sniped off old defrost thermostat.

Spliced in new part. reconnected power and it's up and running.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Edith from Langhorne, PA
Parts Used:
241885001
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Screw drivers
Freezer leaked, no water disp. & Crusher didnt crush
First I defrosted the entire unit, both sides for 24 hours. Restarted, I now have water dispensing. (It had apparently frozen) Next I took out the ice crushing part and took it apart, (a few screws) by removing the broken floppy piece; the small plastic floppy door that allows ice to crush, replaced this small piece, rather than replacing the entire big plastic piece that I ordered. Used a slot screw driver removed the old floppy piece that was broken and removed the same piece from the new one and switched them out. Reassembled the entire unit (a few screws), put the ice back in and it works great. I got the instructions for taking apart this from this site, however, it was fairly easy to figure out. Just be patient with the plastic parts.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
David from PFLUGERVILLE, TX
Parts Used:
240350649
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Crisper Glass was broken
Took the glass out of the shipping box and it just slid right in. It was a perfect match.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
David from Lehman, PA
Parts Used:
5303918344
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver
The icemaker was making a clicking noise. The paddle that moves to let the ice drop into the ice container had trouble moving the new ice so it could retract.
This was one of the easiest repairs I ever did. All that is needed is a nut driver. Turn off the freezer. Remove the ice container. The two screws that hold the ice maker only have to be loosened since the mounting holes are keyhole shaped. Loosen the screws, slide the icemaker up, unplug it, and remove it. Plug the new one in, place it over the scews, drop it in place and tighten the screws. Replace the ice container. Turn on the freezer. Turn on the ice maker, run it through a cycle, and job is complete. Took about five minutes, start to finish. The water doesn't have to be turned off since there is no direct connection to the ice maker.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Robert from JACKSON, CA
Parts Used:
5303918344
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver
OLD ONE HAD LOST ITS TEETH OVER THE YEARS
JUST CONNECTED THE WIRE HARNESS, TIGHTEN THE TWO NUTS WITH AN NUT DRIVER AND TURNED IT ON. WORKS GREAT!
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Nancy from ROGERS, AR
Parts Used:
240350649
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
While washing the insert, I dropped and broke it.
Ordered the correct part according to the specifications; took the packing plastic off; and placed it on the crisper. Ta Ta!
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Jessica from Sugar Land, TX
Parts Used:
240350649
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Refrigerator glass shelf replacement
The previous tenants broke the glass shelf in the refrigerator and all I did was order the part and place it on the refrigerator shelf. Very simple and I ordered the correct part thanks to the refrigerator diagram the website had.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the EI23CS35KS3A
121 - 135 of 304