Models > CRT215PB2 > Instructions

CRT215PB2 Crosley Refrigerator - Instructions

Jump to:

All Instructions for the CRT215PB2
121 - 135 of 467
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Leora from Portland, OR
Parts Used:
240337901
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Shelf broke
Opened the door, aligned new shelf with the prods attached to door frame and then put it in.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Chasya from SCOTTSDALE, AZ
Parts Used:
240338001
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Just bought a condo and fridge door bin was missing.
Looked up model number online and found this site . Prices were reasonable and ordered the bin. It snapped right into place.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Kasey from O'Fallon, MO
Parts Used:
240338101
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
had no shelf bin
Just snapped it on.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Jesse from Edmond, OK
Parts Used:
240337901
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
My door shelf broke where the tabs connect to the door
I slid and locked the new shelf in place, easy!
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Jerome from Lakewood, OH
Parts Used:
240337901
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Broken shelf retainer
It was simply a matter of slipping the new retainer into place -- a ten second job. I was VERY pleased with the service I received through PartSelect.com -- the part was available and was shipped immediately. I had it in two days. Thanks.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
VIRGIL from JERSEYVILLE, IL
Parts Used:
240338001
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
broken door bin
very simple--pull out damaged bin then snap new bin in. takes all of approximately 10-15 seconds.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
James from PHILADELPHIA, PA
Parts Used:
5303918202
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver
Evaporator was freezing up and was running non stop
I tested the components in the refrigerator defrost function. I used digital multimeter and checked for continuity. Defrost thermostat must 32 degrees or lower.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Joyce from LEXINGTON, KY
Parts Used:
240358928
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
The plastic frame around the shelf broke!
Only thing we needed to do was to slide in the glass shelf into the grooves inside the refrigerator!!
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Cindy from South St Paul, MN
Parts Used:
240338001
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
My son open the refrigerator door and the ketchup was on the top of the shelf and it broke it off
Just snapped it in it was that easy
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Diana from N LAS VEGAS, NV
Parts Used:
240350609
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
The glass shelf broke above the 2 drawers on the bottom
Just lay the new glass shelf into the groves. The shelf was too big and would not fit properly down into the groves.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Michael from TUCSON, AZ
Parts Used:
240505801
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
Light not turning on when door opened
Used a flat head screwdriver to pop out the old switch, removed the contacts and placed on the new switch, popped the switch back in. Done in about 2 minutes.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
JACOB from YOUNGSTOWN, OH
Parts Used:
241537103
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Refrigerator did not cycle
Installation was fairly straight forward. The major complaint is that the problem returned 2 weeks later. I don’t know if I care to re-invest in another switch.
Now what?
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Ben from FRANKLIN, TN
Parts Used:
240524102
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Noisy condenser fan
Remove lower cardboard refrigerator panel. Carefully pull existing cracked fan blade off of the motor shaft and replace with new fan blade. Reinstall cardboard panel.
2 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Susan from VIRGINIA BCH, VA
Parts Used:
241554901
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver
Door switch was no longer making my light go on when door opened
I used the youtube you provided. It was pretty straight forward, but I had to make a trip to the hardware store for a bit (hex wrench) to remove the hex bolt head style screws. I was only expecting to need phillips or flathead. I managed to remove one with a set of pliers, and the brought that example to the store for size reference when buying the bit to fit my black and decker drill. The rest was easy.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Robert from MONTGOMERY, IL
Parts Used:
5303918202
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins
Tools:
Socket set
Coils frozen over. Refrigerator not cooling
I cut wires from bad thermostat and removed it . Stripped wires and crimped connectors on new thermostat and wires from old thermostat. Used heat gun to seal sleeves over connectors. Very helpful video from this site Thanks, you will be my go to parts supplier from now on!!!!!!!!!!!!
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the CRT215PB2
121 - 135 of 467