Models > CRT174HLW3 > Instructions

CRT174HLW3 Crosley Refrigerator - Instructions

Jump to:

All Instructions for the CRT174HLW3
76 - 90 of 195
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Liz from Spring Valley, CA
Parts Used:
218428101
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
needed new refrigerator door handle
took less than 5 minutes had to undo two screws and take out old broken off part and put new handle on and put screws in
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Ty from GREEN BAY, WI
Parts Used:
240535101
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Broke door rack trying to clean it
Install by sliding the rack directly down above the fridge's tabs.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Frank from TORRANCE, CA
Parts Used:
240383901
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Door Shelf Bin broke....A++
Got it replaced and was easy to install
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Cindy from Merrifield, MN
Parts Used:
218428101
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
Door Handle broke when a container came out of the freezer and hit it.
Just put the new handle on with screw driver
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Bill from Bay City, MI
Parts Used:
5304464438
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers, Wrench set
Fridge quit working.
A little research told me the hum plus no cooling was either the compressor or the relay. I ordered the new relay and put it in but it didn't fix the problem. I ended up having to buy a new fridge, but it was worth the $30 gamble to see if I could fix it on the cheap and it saved me the money a service call would've cost. Pretty easy installation, just in a tight space on my model.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
thomas from MATAWAN, NJ
Parts Used:
218428101
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
Handle was broken in half
Followed your instructions and it couldn’t have been any easier
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
JACOB from YOUNGSTOWN, OH
Parts Used:
241537103
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Refrigerator did not cycle
Installation was fairly straight forward. The major complaint is that the problem returned 2 weeks later. I don’t know if I care to re-invest in another switch.
Now what?
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Susan from VIRGINIA BCH, VA
Parts Used:
241554901
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver
Door switch was no longer making my light go on when door opened
I used the youtube you provided. It was pretty straight forward, but I had to make a trip to the hardware store for a bit (hex wrench) to remove the hex bolt head style screws. I was only expecting to need phillips or flathead. I managed to remove one with a set of pliers, and the brought that example to the store for size reference when buying the bit to fit my black and decker drill. The rest was easy.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Karla from UNION, MO
Parts Used:
241554901
Difficulty Level:
Difficult
Total Repair Time:
1- 2 hours
Tools:
Socket set
Refrigerator light stopped working
The bulb wasn't the issue so I was hopeful the switch was. utube helped me some, but figuring my model was different than any on utube. Got the switch in and plugged it back in. Moment of truth. Didn't light. Ugggh! Out $50 for switch plus $20 for nut driver set.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Sadrudin from SAN DIEGO, CA
Parts Used:
218396700
Difficulty Level:
Difficult
Total Repair Time:
30 - 60 mins
The hole on the handle mounting block was too low
I had to loosen the screw holding the mounting block and increase the hole size to fit the screw on refrigerator
1 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
David from VENICE, FL
Parts Used:
5303918202
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver
Refrigerator evaporator coil was icing up
The evaporator coil is behind the freezer. Remove the rack that makes the shelf and remove two 1/4” hex head screws I the back of the freezer to access the coil.
I used a hair dryer to melt the ice off the coil.
The thermostat clips on the refrigeration pipe to the coil. Remove the old thermostat and cut the wires at least a few inches from the thermostat. Clip the new thermostat on the pipe and strip about a 1/4” of the wire ends. The electrical connectors (provided with the new part) must be crimped to connect the wires.
1 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
francine from brick, NJ
Parts Used:
240535101
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
replacing broken door racks
Super easy it took no more than 5 minutes to replace the fridge door racks. Starting from opening the box when it arrived to closing the fridge door with the new racks in place. no tools needed, except a knife to open the box.
1 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Mordechai from Brooklyn, NY
Parts Used:
240535101
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Easy and simple!
had it done in 5 seconds!!
1 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Steven from MARYVILLE, MO
Parts Used:
240337712
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Needed a replacement door for the dairy compartment
It simply snapped into place. No tools required. A very simple repair.
1 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Cathleen from Potomac, MD
Parts Used:
240383901
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Door shelf bin fixture broke off
This was the easiest thing to repair in my house! All I needed to do was to snap the appropriate new shelf in the place where the prior piece was and we were back in business. A caveat to anyone else who might try it-get your Mfgr/model number straight as well as measure the length of the shelf to be replaced. Since my brand was not listed in the pull-down menu for replacements, the first time I ordered the shelf replacement piece, I ordered the shelf that looked exactly like the one I was replacing however the replacement was a few inches too small! Thank you PartsSelect for an easy return policy and your guidance when I called
1 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the CRT174HLW3
76 - 90 of 195