GB2225PEKW4 Amana Refrigerator - Instructions

Had to push the light switch to get lamp to light up.
Removed power from refrig. and removed old light switch
and replaced with the one I got from Partselect. Turned power back on and was done.

Repair was tremendously easy. All I did was remove old light switch by prying out with screw driver and plugging in the new light switch and pushing it into the hole. Simple! The instructions weren't needed, but they were very thorough.

First I removed the two screws that held the old handle on and placed the new handle on! That's it! It took all of 3 minutes :)

Watched the video. Everything went great, Super simple

The best part of the repair was how easy it was to find and order the part. Instead of searching the parts houses around town I just went to the PartSelect web site, quickly found and ordered the part in about five minutes, received the part the next day at my home and was ready to make the repair. Wow! What a pleasure for something to work the way it was meant to. Removed old switch located by prying out with sharp knife or screwdriver. Don't worry about breaking it or cracking plastic. Disconnect(unplug) wires from back of switch. Replace (plug-in) wires on back of new switch. Insert in location of old switch. Finisheed.

Installed the Dairy Door on the new Dairy Tray. Removed the old tray, replaced the new tray on the refrigerator door. The vegetable and fruit drawers were removed and the glass shelf was removed. The new plastic rail was placed in the slot and the shelf replaced. The drawers were replaced.

The hardest part of this job was to select and purchase the correct parts. Your website mad that task easy.

We had to take a few parts from our broken piece to attach to the crisper. It would have been easier if there were some sort of instructions to get the pieces off. We were finally able to get the metal rod off and attach to the new piece. It was rather easy,

removed drsws and shelf put new center rail replaced draws done

installed new parts

Disconnected electrical plug between ice maker and frig. Removed 3 screws holding ice maker in place and removed ice maker. Ice tray shelf only uses the upper 2 screw locations. It would have been helpful if I had been told that the original screws holding the ice maker would not work because they are too short, and that I would need some special washers/spacers that fit the new shelf. Luckily I had longer screws available and I was able to fabricate the washers from some scrap plastic. Installed successfully.

A very cold and brittle switch in a 17 year old fridge. Used screwdrivers to pry out with some resistance Had to cut the molded plug in half and split wires, because replacement contacts were farther apart than the original. End result, works great.

replaced electric control board, defrost for six hours. next day (24 hours) same problem, [email protected]

Took out both crispers. Removed glass shelf on top of crisper support. Removed small broken piece of rail still held in place. Inserted new crisper rail and put crispers back in place.

I used a knife blade to slip under the edge of old switch to pray it out of the hole it was inserted into, switched the wires and replaced the new switch into the same hole. It took about five minutes!

disconnected el. power to fridge. pried out broken switch with small screwdriner and pulled out w/water pump pliers. installed new switch and pressed into opening.