TP19AW-P1300601WW Amana Refrigerator - Instructions

We replaced the shelf with no tools. Just slid it into place. Literally took 15 seconds.

With this order it wasn't so much the repair that was the issue but the fact that I needed the part right away. I broke the shelf Tuesday night and placed the order just afterwards. By Thursday afternoon I had received the new shelf; one day before my inlaws arrived to visit. I was surprised and relieved the part was in stock. Thanks!

Initially replaced the shelf with clear plastic. Then, after some time, decided to "do it right" and use glass. Found PartSelect by surfing the Internet and was elated to find the exact part needed rather than having to have glass custom cut. The glass shelf arrived quickly, was packed very well, and was simply installed. We were very happy to find this solution.

No tools necessary. Just slipped it into the space. New shelf is far nicer than the original.

Removed the 6 screws that held the panel up, pulled the panel down. Removed the wires on the old switch. Pulled out the old switch, and pushed the new one back in place. Attached the 2 wires, pushed panel back into place and installed the 6 screws. Pluged back in and light works every time the door is opened now.

I removed three screws each on the old handles & removed the handles.
I reversed the process by attaching the new handles using the old screws.
All looks great.

It was so simple. Even I could do it. Place the post in the slot and bingo, the drawers were supported. My brother installed the handle and he said it was very simple. Great service and good quality parts. Thanks.

I simply put the post in and set up the drawers and shelf.

Lifted both drawer runners removed the broken post, put new post in place. Job completed in lest than two min.

Cleaning up the broken glass was the hardest part (Even went into the garbage disposal!). But ordering a replacement shelf was as easy as typing in the refrigerator model number on the PartSelect website. Easy installation after prompt shipment arrival by FedEx.

Pulled out the refrigerator and removed the two panels from the rear of the refrigerator. Removed the fan held in by four screws and unplugged the connector. Soldered on the original connector, installed the fan to the motor and re-installed the unit into the refrigerator. Then blew out and vaccumed the condenser coils.

Noticed fan wasn't running, remo ved, verified that it wasn't a sensor, ordered new part, installed new part...works like new. Everything is cold again!

The hardest part was taking out original light bulb because screws on shield where hard to unscrew after all this years . The old bulb vent out leaving neck in socket. It took narrow electrical pliers to get neck out .The generic appliance bulb did not fit and had aluminum neck ,not recommended for brass sockets in ovens.Putting new light bulb in was not the problem.

Removed the door-the hardest part, placed door on saw horses and removed what seemed to be several hundrded screws. In reality there were about 20 screws!! Replaced the gasket and door and kept it tightly closed with duct tape overnight..It's workin' great. Thanks to a guy named Appguy everything came out fine.

Removed rear cover to see non-operating fan - removed three mounting screws on the motor that were a challenge to access. Swapped fan from old motor onto new motor - one threaded nut on the motor shaft. Spliced new fan wires into fan wires of the wiring harness and mounted with three self-tapping screws supplied with new fan motor. Replaced rear cover and plugged it in! Now the refrigerator cools like new (1981 model side-by-side Admiral)