AB2225PEKS4 Amana Refrigerator - Instructions

removed the 2 screws that held the panel in place, had to reach up and push on locking tabs to lower trhe front of the panel. was able to then push on the locking tab of the switch to release it. removed the wires, replaced them onto the new switch, and snapped the switch into place. the rest was reverse of the uninstall process.

Replaced crisper

The rail had broken off, so there was nothing to remove, except the crisper drawers. I had called an amana repair service and the repairman told the part was about $9 and the cost to install was $127. When I almost fainted, he told me I could probably do it myself. Wow, was he right! I ordered the part, it came in about 2 days, I looked at the rail, removed the glass shelf, hooked the rail into the little opening at the back, and bang! All done. It took me 10 seconds!!

Great service. Unpluged old switch and pluged in new one. Works great

took glass out ..put new rail piece in took 2 minutes

I placed the back of the bracket into the slot in the rear of the refrigerator and stretched the front plastic rim on the glass shelf over the front of the new center rail until it snapped into place (all the while hoping I didn't cause further damage to my refridgerator!) and wa-la, piece of cake! My impatience paid off this time!

Finding the part that I needed was incredibly easy. I usually leave all repairs to my husband but I was getting frustrated that my vegetables were freezing due to the drawer laying right on the wall dividing the freezer area. I took it upon myself to search for parts by using the refrigerator model number, This site is the BEST!! By providing pictures of the parts and where they go I was able to order the correct one. It arrived within a few days and I installed it in less than 5 minutes. I was relieved that I had ordered the correct part and my husband was pleasantly surprised that I took care of it myself. Thanks

I had to remove the 2 drawers, naturally, but then found I also had to remove the glass shelf and bracket that holds them, because the end of the center rail had broken off and stuck in the recess of the shelf. No problem. Washed the shelf and the end piece fell out, eliminating the need for pliers or tweezers. Put the new center rail in place, replaced the shelf, replaced the 2 crisper drawers and, "voila" - good as new (until next time some big, strong guy slams the crisper drawer). Thanks for quick delivery; I don't often get in the mood to fix things, so when I do it's nice the part arrives before my fixing-muse flies away.

After disconnecting the electricity. I followed the instructions as indicated in the "HOW TO" article on the website. I used a steel putty knife and pried the light switch out of its retaining hole. I worked the right side the most since this is the side with the retaining clip. After I removed the switch I transferred the two electrical outlets to the new switch and easily snapped it into place. Engaged the electric power and tested the switch.

Took off the broken rail and dropped in the new one with only a slight pressure of the plastic shelf frame shelf. Took about 30 seconds.

Removed drawers, lifted glass shelf, installed new part

I simply removed the drawers and replaced the assembly. I didn't even need tools!
The part arrived so quickly and it was easy to find. I will definitely use part select again!

Used a screwdriver to pry loose the old switch, swapped wires to the new switch and pushed it into the opening. Took about 2 minutes.

I used a knife blade to slip under the edge of old switch to pray it out of the hole it was inserted into, switched the wires and replaced the new switch into the same hole. It took about five minutes!

As I was holding the part up, I didn't know it was a separate piece from the frame. The reason that initially it didn't come apart is because a sticky substance had sealed it. Once the water started, the sticky stuff melted and the glass broke into a million little pieces.