Models > ART318FFDW03 > Instructions

ART318FFDW03 Amana Refrigerator - Instructions

Jump to:

All Instructions for the ART318FFDW03

Customer:: Heather from Marysville, WA
Parts Used:: WP2315539
Difficulty Level:: Easy
Total Repair Time:: 15 - 30 mins
Tools:: Nutdriver, Screw drivers

Refer wasn't cold but freezer was working great

Removed the ice maker (3 screws) removed the back plate (2 screws) Remove the bracket holding the fan in (2 screws) Remove the rubber mounts on the old motor and the fan itself off the old motor. Then put it all back together in reverse order.

Was this instruction helpful to you?

Customer:: Vernon from Carmel, ME
Parts Used:: WP2315539
Difficulty Level:: Easy
Total Repair Time:: 15 - 30 mins
Tools:: Nutdriver, Screw drivers

refrigerator section was not cooling

unplug, turn water off, remove ice maker & unplug,remove back panel remove old fan unit & unplug remove fan remove fan blades just pull off install new fan, put fan blades on new fan & install on bracket & re install plug in re install back panel. plug in ice maker re install ice maker . turn water back on plug refrigerator back in ( quite easy )

Was this instruction helpful to you?

Customer:: ronnie from grundy, VA
Parts Used:: WP2315539
Difficulty Level:: Really Easy
Total Repair Time:: 15 - 30 mins
Tools:: Nutdriver

frige not cold

i removed the back cover off in the icebox,removed the fan motor,replace the new one now it works fine.very easy to do,saved alot of money on a new one.

Was this instruction helpful to you?

Customer:: Angela from Renton, WA
Parts Used:: WP2315539
Difficulty Level:: A Bit Difficult
Total Repair Time:: 30 - 60 mins
Tools:: Nutdriver, Screw drivers

Evaporator fan needed replacing

I actually followed the instructions by William. He did a great job. I ran into some difficulty because the wire connector on the replacement motor didn't match the old connector. We had to replace the connector on the new motor to match the wiring harness, which was easier than trying to match the connector on the motor. Had the connectors matched, the replacement would have taken less than 30 minutes to complete.

Was this instruction helpful to you?

Customer:: Diana from Crocker, MO
Parts Used:: WP2315539
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

The freezer was working but the refridg was'nt cool enough.

Took the old fan motor out and installed the new one. Wow it's getting cool now. Thank You Parts select for the information on your site. Fast shipping. Very pleased I found your site, which stated it was the fan motor 45% of the time. It saved me from having to have a repairman come to my home. I called one but he did'nt work in this area. They gave me another man's number, and I called and left a message on the recorder, but he never got back to me. So I was happy to have found your site. Thank You again!

Was this instruction helpful to you?

Customer:: Skyler from San Marcos, TX
Parts Used:: WP2315539
Difficulty Level:: Easy
Total Repair Time:: Less than 15 mins
Tools:: Nutdriver, Screw drivers

Freezer running, yet fridge warm.

The fridge went warm and I noticed ice build-up on the freezer floor underneath the coils. I mistakenly thought that the defrost heater (or thermostat or timer) must have been the culprit. I used a voltmeter to test those components and chased a wild goose for quite sometime before realizing that the evaporator fan was not spinning and that it failed a test with the voltmeter. Replacing the fan easily fixed my problem! I later realized that the sheet of ice on the freezer floor indicated that the defrost cycle had been working. Were that not the case, the ice would have been all over the coils.

Was this instruction helpful to you?

Customer:: Dora from Rock Island, IL
Parts Used:: W11384469
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins

light would come on and off

Viewed the viedo - it showed what to do

Was this instruction helpful to you?

All Instructions for the ART318FFDW03