ASD2575BRW01 Amana Refrigerator - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Floating baffle and Ice bin auger drum were both broken and needed replaced.
The video of the repair that was on your website was extremely helpful. It showed in detail how to replace the parts item by item. I could not have done it correctly without the video. I believe anyone could have replaced these parts with your instruction video.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Cindy from Kenner, LA
- Parts Used:
- WP2182179
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Socket set
The door would not close tight unless you gave it an extra push
Removed the old cam and put books under the door to hold it up. Follows instructions and really easy
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- mike from ROSCOE, IL
- Parts Used:
- WPW10225581
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers, Screw drivers
fridge too warm
remoove all the food and shelves out from the freezer section, remoove the light bulb lens ( 1 phillips screw) remoove light bulb, take out 6 srews on the back panel then slide out through the top with a slight bending curve motion, the bimetal thermostat will be clamped to the evaporator inlet, ( just after the cap tube) snap it off, then cut the wires about 2 inches from the stat, strip the ends about a quarter inch with wire strippers, same on the new stat, then use 16 or 18 gauge butt splices and crimp them , then reassemble in reverse order.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Kim from Overton, NV
- Parts Used:
- 4388736
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers, Socket set
Broken plastic direct drive drum for ice-maker
My husband and I followed the instructional video on how to replace the "direct drive drum". We took note of how everything looked prior to dismantling the ice bin. We made sure we had the proper tools and a large flat surface to work on and started taking out the screws. Replaced the new drive drum part and put it all back together. The whole process took approximately 30 minutes and the ice crusher works great now. I'm a happy camper!!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Cliff from Pensacola, FL
- Parts Used:
- WP2187172
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Broken refrigerator door shelf.
Ordered a new shelf. Removed the old one and installed the new one. Wife is happy. :-)
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Mack from Los Banos, CA
- Parts Used:
- WPW10225581
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Refrigerator was getting warm
Unplugged it for a day listened to the ice melting on the inside and plug it in again. Decreased the temperature settings and it now seems to work fine. I will save the part in case I ever need it in the future.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- James from Virginia Beach, VA
- Parts Used:
- WP2155013
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Kick Plate Clip Broke
On the left side I unscrewed the screw and replace it with a new one . The right side in had to take s file and file of the rivet. You can use a rivet gun or a metal screw to replaced the clip. Once it is finish open the refrigerator door to see how to line the kick plate into the clip. A piece of cake.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Trent from Poteau, OK
- Parts Used:
- 4388736
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers, Screw drivers
plastic auger drum broke
The video on the site made the repair extremely easy. It took 15 - 30 minutes start to finish. Had it not been for the video I wouldn't have known that the plastic nut on the end of the auger was reverse threaded. I would highly recommend this site for ordering appliance parts.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Ronald from Alamogordo, NM
- Parts Used:
- WPW10169511
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 1- 2 hours
- Tools:
- Pliers
The nut on the motor that turns the augor in the ice maker had striped the treads.
I would not have attempted the repairs without your instruction. I use a Drimel tool with a abravise blade to cut the part off the shaft. After I realized the Drimel tool would work. It took me parhaps 10 minutes to get it off the shaft. I had already ordered the new part and the job was complete. Thanks for the help. Ron Burch
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Russell from East Greenwich, RI
- Parts Used:
- 4388736
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Pliers, Screw drivers
Auger was broken
Went as planned. Video was such a great help. Delivery was in world record time. Price was right. Will use you again.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Grant from Alexandria, VA
- Parts Used:
- 8009
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Light bulb failure
Received the part the day after ordering. Appreciated the quick service and repair took less than a minute.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Frank from Alabaster, AL
- Parts Used:
- WPW10225581
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
freezer forming ice on back panel, fridge nor freezer getting cold
Watched video of repair. Took all drawers and drawer holders out of freezer to acesss back panel. Removed 6 screws from back panel,slid up and out. Cut 2 wires to remove old bi-mtl defroster. splice the wires and attached new bi-metal def.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Loren from Reeds Spring, MO
- Parts Used:
- WP1119018
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Pliers
Part broke inside ice cube tray
Using instructions found on the internet and the illustrated parts breakdown it was just a matter of following instructions.
Was this instruction helpful to you?
Thank you for voting!