Models > BHK2-P1100602W > Instructions

BHK2-P1100602W Amana Refrigerator - Instructions

Jump to:

All Instructions for the BHK2-P1100602W
1 - 2 of 2
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Daniel from Englewood, CO
Parts Used:
D7863101, D7863001
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
Handle pads were broken
Remove the three small screws keeping the old parts on The handle then place the new ones on remembering the position that the old were in replace screws .... that's it !
3 of 8 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Jeff from Greenwood, DE
Parts Used:
D7863101
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Pliers, Screw drivers
refrigerator would not cool/freeze
After an hour of searching the wire schematic diagram on the rear of the box , i looked for an obvious problem. Once I learned that this unit has a defrost switch built in in the control panel under the kick plate on the front of the unit, I pulled the large box out to reveal the small control panel with diods and computer chips mounted on the board with 8 wires running to that board, I learned that a mouse had somehow gotten into the box and crawled across the chip board, there he was fried and apparently the current continued to flow through his body and when the deterioration process reach acertain point my Amana decided it would not work. It was a very expensive unit and was told it would last 30 to 40 years with maint. So far it has lasted 17 years. Anyway replaced switch and the front handle of the unit while I had it apart for a good cleaning. The handle was a cinch.
Thanks
Jeff
0 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the BHK2-P1100602W
1 - 2 of 2