GT2128PDCW Amana Refrigerator - Instructions

tricky part was removal of the old drawer rails. they have a little nub that sides in but does not slide out (the nub is a small triangle piece) so easily. needed to revmove the nub by use of a chisel (sharp knife would work). once that nub was gone the old rail slipped out and the new one slid right in.

removed shelf, removed sllides and replaced

I had a heck of a time getting the broken rail off the drawer. I had to pry quite a bit with a screwdriver to get it to slide off. Other than that, it was like falling off a log.

Removed screws securing the inner door compartment, installed new gasket on door compartment and reinstalled inner door compartment.

I opened the box, unwrapped the new ice pan, gave it a cursory rinse, and put it in the freezer.

I noticed that the refrigerator was having trouble maintaining temperature. Thought it might be time for new one until I found out that a new frig was $5k to $7K. Just happened to notice that the light switch didn't look quite right (was not sitting sqaure to the door). Once I pressed it it came loose. I then realized the the lights were staying on (50 watts of heating). Replaced the switch and the frig started working like new.

Was amazed that I could find parts for a model more than 10 years old. Hardest part was figuring out which was the left rail and which was the right. Then it was a snap with no tools

Took out lower shelf. Unscrewed screws holding two broken shelf supports and removed broken supports. Replaced with new supports and screwed in the screws. Nothing to it.

Part was easy to order, delivered quickly, installation very easy. Just unplug the unit, pop out the old swich using a screwdriver, disconnect and reconnect leads and pop switch back in. Definitely recommend that you can do it too.

Pry old switch and pull out. Disconect two wires. Put two wires on new switch, must be inserted right and connections not loose. Put switch in, making shure wies do not come off and snap in place

It was a shelf, all we had to do is clean up the mess and replace it.

removed the 2 screws that held the panel in place, had to reach up and push on locking tabs to lower trhe front of the panel. was able to then push on the locking tab of the switch to release it. removed the wires, replaced them onto the new switch, and snapped the switch into place. the rest was reverse of the uninstall process.

Remove rails by sliding toward the rear of the draw, remove screw holding roller wheels with screw driver, install
rollers onto new rails, tighten screw, and insert new rails.
Force rails forward till rail locks into place.

Unplug appliance. Socket wrench to unscrew two screws. Module drops down. disconnected two press-on wires by prying off with screwdriver. Removed old switch. Press-fit new switch. Reconnected two wires (color coded). Screwed module back in place. Plug in appliance.

After disconnecting the electricity. I followed the instructions as indicated in the "HOW TO" article on the website. I used a steel putty knife and pried the light switch out of its retaining hole. I worked the right side the most since this is the side with the retaining clip. After I removed the switch I transferred the two electrical outlets to the new switch and easily snapped it into place. Engaged the electric power and tested the switch.