2699A Amana Refrigerator - Parts

This icemaker water inlet cup is three inches long. It is all white in color and is made of plastic.

This refrigerator kick plate grill is sold individually. Order two if you need to replace both clips. *Please note, if you are ordering the kick plate, check with your model number as these parts may be included.

This part will cut out at 48 degrees Fahrenheit and kick back in when the temperature drops to 33 degrees Fahrenheit.

This right side shelf support is just over an inch long. It is all white in color and it is made entirely of plastic.

This is the replacement ice maker auger and crusher blade assembly for your refrigerator. It is approximately 15 inches long and 7 inches wide. The ice maker auger sits within the ice maker assembly a...

This wheel is sold individually. It is located on the bottom of the refrigerator.

This is a compression nut for your refrigerator/freezer. The compression nut is used with the plastic water line for the icemaker assembly. It is the connection between the water supply line and the o...

This part is the replacement shelf support for your refrigerator/freezer. It is made of white plastic and is approximately 1 inch by 1 inch. The shelf support attaches to the side of your refrigerator...

This is the primary valve (before the water filter) and it replaces the Y-Connector - comes with instructions.

This evaporator fan motor is located in the back of the freezer, and circulates air over the refrigerator coils. These coils will convert the heat into cool air, which is then circulated.

This crushed ice bucket is nineteen inches long and fourteen inches wide. It is all white in color and is made of plastic.