AFF2534FEW Amana Refrigerator - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Charles from Middletown, OH
- Parts Used:
- D7824706Q
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Ice maker not working
Followed on line instructions. Instructions were very helpful. The part was an exact replacement. Everything went as planned.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Don from Desert Hot Springs, CA
- Parts Used:
- D7824706Q
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Screw drivers, Socket set
Was Not Making Ice
Followed the Video, and it went almost as the video, except for the rails for the ice tub, so instead of the nut driver, had to use an open end 1/4" wrench. Now its a working with lots a ice....
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- BETTY from HOCKLEY, TX
- Parts Used:
- D7824706Q
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver
Icemaker
I received the new icemaker the next day after I had ordered it. After watching the video on how to install the icemaker I installed it within a few minutes which I really surprised myself since this was my first repair job to do by myself. The new ice maker has been working great and I am very pleased with partselect and will continue to contact you when I am in need of any parts. Thank you, betty
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Edward from Philadelphia, PA
- Parts Used:
- D7824706Q
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Screw drivers
dripping and making globs of ice
1 removed ice basket 2 remove cover over basket 3 unplug power cord 4 loosen top screws with 1/4 in nut driver (do not remove the completely) 5 remove lower mounting screw ( not necessary to remove basket rail) 6 remove ice maker from unit 7 remove bale from old unit 8 install bale on new unit 9 remove front cover from old unit 10 remove power cord from old unit 11 plug in cord to new unit 12 install old front cover on new unit 13 mount unit in freezer 14 hang unit on top screws 15 install bottom screw 16 plug in unit 17 put in ice basket and cover. no runs, no drips, no errors. Ice was made in about 2 hours.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Tony from Litchfield Park, AZ
- Parts Used:
- D7824706Q
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Ice Maker stops working..
Fast delivery...Great video instructions..The only difficulty is when I tried to take the cable out. It's kind of hard and far away from my reach. So, I took only the cable out on Ice Maker end.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Catherine from Punta Gorda, FL
- Parts Used:
- D7824706Q
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Ice maker tray in side by side leaked and created large lumps of ice
Unplug refrigerator, turned off water to ice maker, unscrewed bracket, lifted ice maker off clips, pulled out water hose,disconected wiring harness and lifted out old icemaker. Reversed the process and it worked like a breeze and no service call. Space is very tight and you have to do a lot of feeling without actually seeing what you're doing and you need a small flashlight. It was so easy with diagram provided on PartSelect's website.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- JANICE from FORT PIERCE, FL
- Parts Used:
- WPW10326469
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
center rail broke
Replaced the center rail
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- John from Seabrook, NH
- Parts Used:
- D7824706Q
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Nutdriver, Screw drivers
Stopped making ice, leaking water into freezer to kitchen floor!
Found PartsSelect on internet. Read data, watched remove/replace video, ordered new Ice Marker. Arrived in 11/2 days-quick. Both removel and install very easy; three easy to remove screws, disconnect wire harness pull it out. However, water cup on end of the new Ice Maker was faceing 90 degrees the wrong way! Had to totally disassemble both new and old Ice Makers to swap water cups. Reassemble, pray it was done correctly and install. New Ice Maker works like a champ and no leaking--Thanks PartsSelect.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Fred from Warwick, RI
- Parts Used:
- W11396033
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers, Screw drivers
My refrigerator light did not work.
After years of using a flash light to check the contents of my refrigerator, I decided to try to fix the problem myself. Replacing the light switch was very easy. The directions were straight forward and I'm sorry I waited so long to tackle the problem.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- James from Davie, FL
- Parts Used:
- W10874836
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver
Hinge snapped off the pasntry end cap disabling the deli door
This is the second order we have placed from Partselect. It arrived within two days as promised. The repair took about ten minutes and consisted of removing the deli drawer, removing the broken end cap, removing the slide rail from the end cap, cleaning out the area with a sponge, attaching the slide rail to the new end cap and installing the new end cap. The deli drawer easily slides onto the rails and the deli door easilt locks into place within the side rails. We were unable to locate the part locally and from now on, Partselect will be the first place we look for an appliance replacement part.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Chris from Amherst, MA
- Parts Used:
- W10874836
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers, Socket set
Broken lower drawer lid hinge
Removed drawers from fridge, removed screws/bolts from end cap, removed end cap with busted hinge pin,installed new end cap with lid , replaced drawers
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- charles from lima, OH
- Parts Used:
- D7824706Q
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Screw drivers, Socket set
not making ice
Move refrigerated and turn off water and unplug elect. Remove ice Ben and guide on right side. Move one screw on the bottom and lousen tow screws on top. Remove ice maker to unhook electrical connection. Transfer parts from old one to the new one . Revise the removal of it and when done .Plug in cord and turn on water. If you have done everything very carefully you will have ice in a few hours.Good luck.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Edward A from St Joseph, MO
- Parts Used:
- W10874836
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 1- 2 hours
- Tools:
- Socket set
A bit difficult to reach inside the refrigerator
I used the feedback information from others who commented on your website
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- BRET from SAN DIEGO, CA
- Parts Used:
- D7824706Q
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver
Ice Maker was not functioning
I followed your posted video. Did step by step as video instructed and in about 30 minutes finished. Ice was made approx 30 minutes later. I hope you do more videos, a picture is worth a thousand words.
Was this instruction helpful to you?
Thank you for voting!