Models > GS20C6D3EV > Instructions

GS20C6D3EV Admiral Refrigerator - Instructions

Jump to:

All Instructions for the GS20C6D3EV
121 - 135 of 144
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Louis from Beloit, WI
Parts Used:
W11384469
Difficulty Level:
A Bit Difficult
Total Repair Time:
Less than 15 mins
Light did not come on (bad bulb!) on TC18KL
I have never before seen a bulb with the filament intact not light. If the bulb's filament seems intact, screw the bulb into a known working lamp and see if it lights. When screwing it back into the socket in the fridge, it takes a bit of extra effort to fully seat (until it does, it won't light!). For replacing the switch, I unplugged the unit, used a paint scraper and worked it under the switch bezel from the right side. A bit of moxie, and the switch came out. The replacement switch had a different spade contact spacing than the original. I used a pair of scissors to cut the rubber bridge between the two switch wire connectors so I could connect to the new switch. In the end, it turned out to be the bulb. NOTE: The Model TC18KL is _not_ listed! What I finally found that the number "P7803211WL" on the sticker is actually a manufacturing code. Found this out by searching, and Sears' part search came up with matches.
Was this instruction helpful to you?
Thank you for voting!
Customer:
TinTina from Bruce, WI
Parts Used:
W11342242
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
plastic stopper came off arm
with a mirror to see the small hole on the front side of the icemaker.... very simple, took 1 minute
Was this instruction helpful to you?
Thank you for voting!
Customer:
John from Niles, MI
Parts Used:
WP52085-29
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers, Screw drivers
Refrigerator not cooling
Unloading the freezer and removing the back panel were the most time consuming aspect of this repair. Many models only have 4 screws, but this one has 9, and being a side by side it was a tight fit to reach them. Once defrosted we tested the thermostat, found it "dead", and ordered a new one. The part came within 3 business days. Installing it took minutes, since we had not permanently screwed in the back panel again. We didn't want to reload everything until we knew things worked properly, so we didn't put everything back right away. We thought we had further problems as the freezer got really cold but the frig still didn't get down to temp. Turns out we just needed to reinstall the fan shield which we'd taken off along with other parts to access and check the vents. The fan shield must be in place to direct the cold air into the vent to the refrigerator. Duh! It was an oversight that once caught made total sense! Now all works fine on this 20 year old Maytag side by side!
Was this instruction helpful to you?
Thank you for voting!
Customer:
Norman from Issaquah, WA
Parts Used:
70197-1
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Magic Chef Refrigerator Door Shelf
My Magic Chef Refrigerator Door Shelf Retainer somehow got lost. When I contacted PartSelect they zeroed in on exactly what I needed. Service was great and I will do business with them again. Norman MacDonald Issaquah, Washington State
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the GS20C6D3EV
121 - 135 of 144