RDE6300G2 Whirlpool Range - Instructions

Searched the internet for the replacement part, placed the order and then disconnected the old one and inserted the new burner prongs into the socket. Worked perfectly!!!

I lifted the stove top and cut the two wire connected to the block. Attached the new wire connectors, new block and checked to make sure it was working. The part that took the longest was getting the screw out of the mounting brracked(it was corroded on). I sprayed some WD40 and waited 5 minuts, it came loose. Then i mounted the new bracket and installed the burner. double checked everything and lowered the top. Done

The bake element died after 20+ years. Turn off the power at the breaker panel. A Phillips head screw holds a plate over each side of the bake element. After unscrewing the plate, you will notice an electric lead attached to a female clip slips onto the end of each side of the element. BE CAREFUL not to lose the clip(s) in the insulation after taking off the male end of the old element! I used a clothes pin to keep the clip from slipping away. If the clip slips away you'll have to fish it out of the back of the oven and that means pulling the oven out of the wall. Sound like fun? I thought not. Take the opportunity to clean your oven also. That was the hardest part. Clip the end of the new element to each of the clips, right and left side, replace the plate and screw in the Phillips head screw. Turn back on the power in the breaker panel. Voila! Done!

Had to screw off old terminal block & screw on new one

I noticed that one of the burner blocks was completely burned and the others were corroded. I ordered blocks for all four burners. Installation was easy except for one block. The screw holding the bracket to the range top was completely corroded in place. I used a correct size easy-out, which is a left hand tap and drill, to remove the screw. That took about five minutes, including tracking the easy-out down in one of my many toolboxes. The entire replacement of four blocks took about one and a half hours. Stove top cooks like new on all burners! The part kit had all the right parts and they fit like a glove!

After turning off circuit breaker to the stove, I removed all surface units , removed the 4 screws holding the top and lifted up. The plug in was burned out (the wire was burned). Look at the old plug-in so as to be able to match the new one and insert the pre- crimped end of wires into the block and the block into the metal holder that matches your old one. (The kit comes with 2 different metal holders)After this, cut out the old wires and wire nut the new wires with the stove wires. Put shrink wrap protector on the wire nuts and heat to shrink it tight.attach the block to the stove top and wa la its done. Very easy.