NE59J7850WS (AA-0002) Samsung Range - Instructions

This was a simple repair. Ater unplugging the oven from the outlet, and removing the oven racks, it was simply a matter of using a long handled Phillips screwdriver to remove the one screw holding the original heat sensor in place. It was not necessary to remove the oven door. There was no need to remove the existing heating element. After the screw was removed, I removed the back cover of the oven (held together by several screws). Unplugging the existing sensor took a bit of time since it was difficult to press down on the clip to separate the wire from the connector. After releasing the sensor wire, it was simply a matter of feeding the old sensor wire back through the oven and removing it from the oven. The new sensor from this site was installed by reversing the removal procedure. It clipped into place easily. I reinstalled the back plate to the oven, connected the oven to the 220 outlet and was done. The oven heats perfectly.

Pulled off the back panel (6 screws) thermostat was right there removed 2 wires and replaced with new put the panel back on done

My repair went terrible as I was sent the wrong motor 2 times. My stove sat in the middle of my small kitchen for 2 weeks. Finally the 3rd was the correct one except I didn't have the right nut so I waited another day for that to be sent. Everything working good now, I just hope the bottom fan doesn't go out after this experience.