F5558*0 Roper Range - Instructions

I removed the entire burner assembly to avoid having to turn things off at the breaker - the whole assembly can be removed completely from the stove I had. Once it was out and disassembled, the toughest part was putting the new wires into the new block correctly. Once that was done, I had to select the right mounting bracket - there were 2 in the kit. Easy, just attention to detail. The rest of the instructions were easy to follow, re-doing the wires. The re-assembly was trivial, and it worked first time!

After carefully inspecting existing burner receptacles, I unscrewed them, raised and propped stove top. Determined which bracket to use from new kit and proceeded to cut and strip wires, twist ends together with supplied ceramic caps and heated shrink wrap on that junction. Works great. BTW got parts in 2 days in great shape and good directions.

Removed old agitator and replaced with new one.

The repair took only 20 min from start to finish. First I removed the liquid softener basket then I removed the cap that is below and with a 7/16 socket I removed the bolt that holds the agitator on , pulled the old agitator off and placed the new one on , put he bolt back in then the cap then the liquid softener basket and started a load of laundry vey simple. please note that when placing the new agitator on you must turn it until it falls into place because the shaft that holds the agitator is splined like a gear. and be sure not to over tighten the 7/16 bolt because there is a rubber washer and that is stated in the directions that came with the part