L3521XRA Norge Range - Instructions

first I removed the 2 screws, I then pulled the element out., accidently lost one of the wire in the insulation and had to take the back panel off which was 8 screws. Probably doubled my time. I received my part in 4 days thanks to good service and FedX It arrived the day before Thanksgiving. Just in time, Thank You All.

The hardest part was taking out original light bulb because screws on shield where hard to unscrew after all this years . The old bulb vent out leaving neck in socket. It took narrow electrical pliers to get neck out .The generic appliance bulb did not fit and had aluminum neck ,not recommended for brass sockets in ovens.Putting new light bulb in was not the problem.

First I disconnect the breaker. I removed the defected receptacle and cut the wires. I connected the new receptacle with parts with the new part. Turned the breaker back on and everthing worked fine.

the new elements were super easy to replace. the old ones just pulled out and the new ones easily pushed in. the top one was a little more difficult only because it had brackets that had to be slid of and then slid onto the new one.

Broken part was already removed, so I used the screw from the broken support and installed the new support. Very simple, easy, and painless.

Called repairman, he never called back for a week. Gave up and found your website, ordered the part. You said it would take 3-5 business days. You lied, it was there the next day. Taking old element out starts with shutting off the juice. Remove trays, pans, etc. Unscrew two screws, pull out elements ends, unclip from wires, reverse the process with new one. You need a light to do this.

took out old element, replaced with new.

First I removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires reverse the order to install the socet was easy but after i was done discovered that the base of the old bulb was stuck in the socet keeped it for future use

removed drawer from track replaced supports on track and one on the drawer.

I unplugged the stove. Took out the burner and removed receptacle by pulling it out of the bracket and clipping the wires. One thing you want to make sure is that when you clip the wires from the receptacle you're replacing you leave enough wire so that you can connect them to the wires on the new receptacle when it is in place on the stove. I had just enough but would have liked more. The bracket I received didn't match the one on the stove so I used the one on the stove since the receptacle itself was the same as the one I was replacing.

Turn power off, lifted door of swing hinge, remove convection fan plate screws, remove screws on element bracket, remove from recess far enough to unplug connectors, reverse order to assemble.

I am really impressed with partselect.com. I ordered the part on a Saturday evening after my oven quit. By Monday evening I had an email showing it shipped and received it on Wednesday. The fit was perfect and the fix was quick.

First I removed the two screws at the back of the oven that hold the element in place (a flashlight is useful for this). I then pulled the element out about 3 inches and disconnected the wire connectors. Connect up the new element and replace the two screws. Dead simple and quick to do and saved us buying a new stove!!!

Very easy, clip on connections and two screws to hold it in place.

Called Sears, repairman couldn't come for a week and would cost $129 for visit not including parts. Went to Sears repair store, part cost more than the part I had already found online and would take a week to arrive. Ordered the part online, paid for next day delivery, watched a video on how to replace. Had my oven back in two days and $59!!!