CLY2260BDB Magic Chef Range - Instructions

So simple would be embarrassed to give any instructions; it is so self evident.

I was disappointed that directions did not come with the part, as I had never before made this repair. However, I turned off the gas connection, unscrewed the oven from its place in the wall, then removed the racks in the oven. Next, I loosened the nuts and screws of the pilot assembly in the oven and loosened the connection on top under the stove. Behind the stove, the copper wire of the thermocouple was fastened together with the others, so I disconnected that and removed the assembly. Next, I uncoiled the new copper thermocouple wire and fed its stove connection through the top rear of the stove, fit it to the connection, and tightened it. Then I fed the other end (with the pilot) through the back of the stove and connected it to the pilot brace. Tightened nuts into place, replaced oven racks, and screwed oven back into the wall. Turned on the gas, lit the pilot, and it immediately lit the stove! I would really have preferred directions, though. I felt intimidated by the whole thing, doubting myself as I made every step. So many ways to screw up...

Remove two black Phillips head screws from the top of the oven door and two black Phillips head screws from the bottom of the oven door which releases the door from the oven. Remove the two Phillips head screws that hold the handle and discard broken handle. Install new handle onto door and then replace the door. Easy!!!

just put it on

Put new parts on & the only trouble I had , I had no ideal where the or how the Extension flash tubes went on had to take one of the burners off & looked it over & found out it had two little what I`ll call slices in it to put the tubes on after that it all went in place very easyly it all worked just fine